sad panda

 

thats not what i think it is is it?

not what i thought it was but o well.

 

so what did you think it was?

 

if you think it was the b2 then yes

 

not quite sure how i missed this build thread. sounds like its going be be pretty sweet once you're done.

woulda tried to sell you my front axle if i new you were going this direction :sonicjay:

 

i thought it was the Explorer because i didnt see the bar holding the front of the leaf spring lol

 

Was that your B2 that is in the current Bronco Driver mag?

 

yes it is.......seen the issue last nite :thumb:

 

is it in the issue? I haven't went and got it to see if i made it in the readers rides.....I sent them a picture.

 

Had to steal part of the floor on the B2 to repair the body mount brace on the ranger cab, kinda sidelined me for a few hours. Couldn't get as much done as i wanted to today.

Got the cab on the frame though, lots of work still to do though.

I did get a truss and welded it on (before i put the axle under the frame).

 

Did you move the rear axle or is it goingto work where its at???

Work faster LOL

 

I am still gonna need to move it further backwards......i have about 6-7"s i can still move the rear shackle bracket before i run out if frame rail/bumper.......I hope its enough.

I got the more then two people part of the job done now. now i can do the rest solo during my evenings.....I still got over a month oke: ............hows that jeep running oke:

 

Jeep runs great till I hit high R's and run out of fuel, fixing thar Thurs:thumb:

 

Thought you weren't going to reuse the old frame?

 

I changed my mind, Figured it wasn't worth the effort to rerun fuel/brake lines and pull the motor out etc...

 

I was wondering why you was using the old frame. I thought it was bent? Or dont you care that much?

Best Car & Motorcycle Insurance | Auto/Moto Protection Today | FREE Trade-In Quote

 

the bottom rails (flat spot under cab) is tweaked slightly, oh well

 

Fix it up a little and be done with it. You will be fine.

Best Car & Motorcycle Insurance | Auto/Moto Protection Today | FREE Trade-In Quote

 

 

gears were donet he day after i posted that :thumb:

 

Are the wheels done yet?

Best Car & Motorcycle Insurance | Auto/Moto Protection Today | FREE Trade-In Quote

 

nope ran the work welder out of gas :teehee: finish them up at home and stopping on the way home to get all the bolts/nuts/washers

 

What grade?

 

You got a thing for purple all of a sudden? :teehee:

 

the other two rims are welded and grinded.....and stopped and got all the bolts/nuts/washer tonite on the way home from work.....

 

It helps to have a trail run to push for but man your ambitious, Nice work. You didnt buy that $80 truss from Summit did you Mr CheapThrillB2?

 

nope, not from summit and not for $80 :teehee:

 

mounted and aired up, no leaks found thus far