Great Lakes 4x4. The largest offroad forum in the Midwest banner
501 - 520 of 1,234 Posts
Discussion starter · #501 ·
both seats mounted
Image

i picked up another 5 point for the pass side but don't like the way it mounts, so i am in need of another one again.

took some shots of the front susp. heres the LF at ride height
Image


heres the Front diff at ride height, i was concerned about clearance of the diff to engine cross member
Image


heres the diff as stuffed as i can get it in my yard,
Image


heres the fender to tire at flex, the tire just fits inside the fender without rubbing to bad
Image


heres the droop on the RF
Image


all pics were taken at the same time without moving the truck, i would like to get a chance to run up on an RTI ramp or similar to max test the flex. Haven't gotten the chance to do that yet.
 
Discussion starter · #505 ·
oh got some stuff done......just about ready for the Badlands May 2nd.

Got the cage painted and welded in some more bracing etc....Cage is down for now till after the Badlands. Got the Pass Seat mounted and the 5 point i got from General (thanks Buddy) mounted up. Also mounted my CB to the top of the cage at the cieling.

Heres a shot messing around with Holshotracers Rig
Image

Image

I also worked on my rear and front bumper. You can see in the above pic how wide the bumper was. I took about 5 inches off each side.
Image


then a clubmate made me some D-Ring mounts so i got those installed
Image

Image

got two in the front as well
Image

Then i had some diamond plat laying around so i added that to the bumper as well
Image



Next i'll be getting 2 DOT approved Fire Extingquishers to mount on the cage in the B2 as well.
 
Discussion starter · #514 ·
newest mod............
Image

Cost me all of $15 and about 20 minutes of my time.....need to figure somethig different for the handle. The linch pin works enough for me to try it out around the yard (Fawking Awesome). I'll have to stop at TSC or Ace and find somethign better to use.
 
501 - 520 of 1,234 Posts