:sonicjay:

 

Winning...:woot:

 

Glad I am taking the rf apart to replace the spicer with a yukon, bearings were so bad I couldnt turn the rotor by hand.

 

Put that on my list to check...

 

I just realized I have zero ground lighting. Right now its just my 2 headlamps and brake lamps. So I just ordered entirely to much $ worth of lighting. Hoping some show up before Thursday lol.

Gonna try to build a shelf in the front of the enclosed trailer before thursday as well. Alas I am no carpenter though :sonicjay:

 

Need some MDF? I can get some to Beefy for you if you don't get it done before the trip... I can bring Laminated stuff for the bench top or raw sanded...

Let me know, and I am cheap...:thumb::beerbang:

 

bring a couple sheets of 3/4 with ya, you would be my hero

 

Just storage shelf to hold some plastic totes, like elec. stuff, and hoses etc..

 

My rock lights are the el-cheapo $15 sets from Autozone.

 

My entire light setup was $70 :sonicjay:

 

mine was not. but I can melt trees down at night :teehee:

they actually were not too expensive (way less than rigid stuff)

 

What did you get for lights?

 

Some no name led stuff. Light bar, some some round floods.

 

Doesn't look like I'll get my lights before the weekend .

I did get both super joints installed and what a motherfawker that was. The reused shaft and stub were a complete nightmare. The ears bent in just a little, what a pita. I bet I had all of two hrs installing just the joint on the shaft.

All bearings and seal replaced on the outers of the front axle.

 

I also got the shelf built in the front of the trailer. I am no carpenter, and my expectations were low. But I am happy with the result. Now I how often I'll smash my head or kyles on it getting on/off the couch :sonicjay:

 

 

:woot:

 

That looks dangerous! Haha

 

Is it time to go yet... Fawk, I'm getting anxious.

 

I foresee beer being drank on that couch.

About 50 LONG hours from now

 

And lots of it

 

Mmmmm lights..

I got 10 of the round ones.

 

You putting that bar under the roof? You roll too much to be out front or on top :sonicjay:

 

:sonicjay:

 

Actually I didn't measure my roof......it might be wider then my roof :sonicjay:

 

Yep, to wide :sonicjay:

 

I'm gonna go measure....

 

Too wide to go on the roof.

 

How wide is it?

 

With the mounts its 53". It advertises at 54". My roof if like 48" lol.

 

You can't use it. I'll take it off your hands for $10. :thumb:

 

8 of the 10 round ones installed. Just need to wire 2 more and done.