Great Lakes 4x4. The largest offroad forum in the Midwest banner

1990 go fast bronco “Uncle Eddie”

25K views 116 replies 14 participants last post by  cj7on44's  
#1 · (Edited)
Just had this delivered yesterday 2-12-22 from southern Tennessee to michigan. The first thing I did was wash the salt off it from its ride up here. Now I start planning out my build. Plan so far is McNeil racing glass and dash Holley efi and going to a built 460. Going to buy extended beams 12” coil overs and cage it. I’m undecided about the rear right now. I keep telling my self just keep it simple with leafs but I also want to just link it lol. As far as shocks go I’m going with Carbon Shocks 3.0 coil over front and 3.0 triple bypass rear. I would like to add a set of twin turbos once I have it up and running which is why I’m going with the Holley terminator x. That’s all for now I will try to keep this updated as I get parts

Image

Image

Image



Sent from my iPhone using Tapatalk
 
#104 ·
been doing some wiring on this thing. Plumbed the fuel system, and fired the motor. I turned an old 4 core cbr radiator in to one that will work with the Coyote. Machined a custom steering shaft. Made some spacers to make the power steering pump replace the a/c pump. Made some panels to enclose the center council. Some exhaust work little bit of everything. Crossing stuff off the list

Image

Image

Image


Image

Image

Image


Image

Image

Image
 
#106 ·
Rear is pretty much all closed back in. Paint and seam seal it this weekend to make sure it stays sealed up the best I can. Hopefully paint the body this weekend. I ordered my rear fenders and they are about 2-3 weeks out. New rear harness are in the way. Next big thing is brake lines.

Image

Image