Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 2 of 2 Posts

· Registered
92 Posts
Discussion Starter · #1 ·
Got a few axles to sell. No pictures today but I'll get some tomorrow.

First is a complete Dana 44 rear out of a late 80's Grand Waggy. Complete drum to drum. Centered pig, 6-lug 58.5" WMS. Built in 2008 with approximately 6000 summer miles and 0 offroad. Cleaned & painted at the time but dirty (not rusty) now. All new brakes when built, new diff cover, Eaton Truetrac carrier. New spicer 4.10 gears less than 1000 miles ago. Asking $500. Buyer can have the 44 front listed below for free if they want it.

Next is a partial Dana 44 front from a 1976 Wagoneer. Passenger drop. Axle housing, axles, spindles, knuckles all good to go. Has an open carrier with 3.54 gears but they are NOT set up. Needs all brakes (backing plates, rotors, calipers, etc) and other misc hardware. Asking $75 if it doesn't go along with the rear.

Finally, a partial rear axle from the same 1976 Wagoneer. Offset passenger drop. No backing plates or brake hardware. Carrier is junk, spit the cross shaft. Have no idea what to ask, but it's cheap. $35 OBO?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.