Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 4 of 4 Posts

·
Terminator 2
Joined
·
1,159 Posts
Discussion Starter · #1 · (Edited)
Hey guys,
Have the following left over from the 304 stroker build.

1) New 1-piece hardened pushrods for V8 (16) - $40

2) New Torque-PLus intake manifold gaskets - $20 ** SOLD **
3) NOS 390 rod/main bearings (STD/STD) (new ... only used to mock up the crank/rods/pistons for decking the engine block) - $40

4) Intake manifold baffle (goes on bottom ... bead-blasted) - $20

5) '79 304 V8 heads. Ported/Polished. Chambers opened to approx. 62-cc. Rough machined for 1.94/1.50 SB Chevy valves. Bronze guide inserts for SBC Valves. Rough machined for screw-in studs and guide plates. - $100

__________________
Sincerely,
GregTaylor
Rochester Hills, MI

1989 Grand Wagoneer "Terminator 2": 330" AMC stroker V8 (about to be dynoed soon). 5" lift 31" BFG A/T's. Killer32 front bumper & DozerII rear swing-out bumper, Water Injection / Hydrogen Injection Coming Soon ... Oh Yeah! And a FISH Carburetor!
 

·
Terminator 2
Joined
·
1,159 Posts
Discussion Starter · #2 ·
bump
 

·
Terminator 2
Joined
·
1,159 Posts
Discussion Starter · #3 ·
bump
 

·
Terminator 2
Joined
·
1,159 Posts
Discussion Starter · #4 ·
new prices

New prices ....

New 1-piece hardened pushrods for V8 (16) - $35

NOS 390 rod/main bearings (STD/STD) (new ... only used to mock up the crank/rods/pistons for decking the engine block) - $35


Greg :)
 
1 - 4 of 4 Posts
Top