Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 4 of 4 Posts

·
Sundowner
Joined
·
476 Posts
Discussion Starter #1
I have a 302 Ford motor with A C4 tranny now mounted to a 208 tcase left drop.

1. Would this bolt up to a 208 right drop (Chevy) this tcase was mounted to a 700r4?

2. Is it possible that a 205 would bolt up to the 208 adapter/ splines?

Thanks
 

·
Axle Guru Extraordinaire
Joined
·
7,921 Posts
you would have to use the ford input in the chevy tcase but both should bolt up, if you find a round bolt pattern 205
 

·
Sundowner
Joined
·
476 Posts
Discussion Starter #3
So i would have to tear down the case to change the input shaft, or do you mean just change the input coupler?
 

·
I am the law.
Joined
·
29,823 Posts
So i would have to tear down the case to change the input shaft, or do you mean just change the input coupler?
Change the shaft. The Ford C4 output has a different spline count than the Chevy 205 input, so you have to use A Ford 205 input.
 
1 - 4 of 4 Posts
Top