Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 6 of 6 Posts

274 Posts
Discussion Starter #1 (Edited)
I have a set of Sanderson CS13 S-10 Small Block Chevy conversion headers. 1 3/4" primary tube and 3" collector. Brand new high temperature gray powder coating. They are 2wd headers but I used them on my 4wd truck and only had to trim the top corner of the drivers side shock mount. I used them for 2 Saturdays at Silver lake before I broke my truck and I am facing reality, this truck will never go back together. They do fit fairly tight to the block so they could be used for other small block applications.


Engine : Small Block Chevy 265-400
Primary Tube Diameter : 1¾"
Collector Diameter : 3.0"
Weight : 17 LBS / 7.71 KGS


16-Gauge Primary and Collector Tube Thickness
3/8" Thick Flange
Patented Flange Design Requires NO Gaskets
Tightest Fitting Header Available Anywhere!
Made in the USA

If your interested I have a set of SBC conversion motor mounts for an S-10 for $40.
1 - 6 of 6 Posts