Great Lakes 4x4. The largest offroad forum in the Midwest banner

Safety info for welders

922 Views 10 Replies 10 Participants Last post by  Kodiak450r
I don't know if this is a REPOST but it still is a good read.
1 - 1 of 11 Posts
I am a victim of this. Cleaning break parts in the shop.
Over spray got on other parts I was going to weld later. Once I started welding it was all over barely made it out of the shop before I blacked out.
This should be a sticky at the top of the fabrication section forever
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.