Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 8 of 8 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 · (Edited)
i have the chase to buy a 1991 Dodge 2500 4x4 does any one know what axles and trans this truck would have. Thank You It is an automatic. It is a gas engine. I want to put the axles in my jeep and see if the trans will fit on 360 with a d300 t case
 

·
Can't lose with 42s
Joined
·
1,055 Posts
King pin dana 61 front....If you want to put gears in it they sell a spacer so you can run dana 60 stuff, not a very desirable front for wheelers but the spacer lets you atleast have some gearing options

Dunno about the rear, probably dana 60/70
 

·
Can't lose with 42s
Joined
·
1,055 Posts
If it were a stick it would be the shitty getrag 5sp with a freakin overdrive for a 1st gear...NV4500 on the 94-ups
 

·
Premium Member
Joined
·
4,651 Posts
King pin dana 61 front....If you want to put gears in it they sell a spacer so you can run dana 60 stuff, not a very desirable front for wheelers but the spacer lets you atleast have some gearing options

Dunno about the rear, probably dana 60/70
Front may be D60, depending on the ratio, some ran 4.10s
 

·
keep your stick onthe ice
Joined
·
907 Posts
gas or diesel? gas should be an a518rh the diesel I'm not really sure.
 

·
keep your stick onthe ice
Joined
·
907 Posts
it should have a a-518 trans that will bolt to any mopar small block. if the truck has a 318 you will need a different torque converter behind a 360. I have no idea about the dana 300. It could have a dana 60 or chrys 9 1/4 rear and the possibility of a dana 60 or 44 front.

I assumed you were using chrysler 360 not an AMC 360 which is probly wrong
 
1 - 8 of 8 Posts
Top