Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 7 of 7 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
I have a NEW, never installed HP D60 front axle. 3.54 gears, complete caliper to caliper.

Currently setup for 2003+ Dodge HD truck. Driver's drop.

8x170 metric pattern. Can easily convert to 8x6.5"

No tierod/draglink, but otherwise complete.

Uses huge unit bearings and balljoints.

$1000

In Kalamazoo.
 

·
Yooper In Training
Joined
·
7,254 Posts
Is this the stock 03+ Dodge axle, or is it an HP60 modded to run Dodge bracketry? If it's the stock axle it's an AAM 9.25, which is still equivalent to the 60.
 

·
Yooper In Training
Joined
·
7,254 Posts
Just checking.
 

·
Can't lose with 42s
Joined
·
1,055 Posts
Intresting setup....
Didn't think dodge ran dana stuff in the 3rd gens...
good luck!
 
1 - 7 of 7 Posts
Top