Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 16 of 16 Posts

·
Registered
Joined
·
680 Posts
Discussion Starter · #1 ·
I have never dont axle joints and could really use someones help on doing them. I have VERY limited tools, no garage, and its my DD. I am hoping to do this before the pig gig so I will actually be able to go on SOMEWHAT of a trail ride. Anybody willing to help me out?
 

·
Moonlight stomper
Joined
·
5,958 Posts
You would ahve to drive to fenton for me to do it!
 
Joined
·
42,948 Posts
I'm closer, but only about 2 miles.

If you want to handle it properly, you would make a post in the meet/greet section announcing you will have beer and pizza, and you need a hand to swap out an axle joint, and that you want to learn how to do it.

Chances are you will have help.
 

·
Registered
Joined
·
680 Posts
Discussion Starter · #11 ·
yes...I will bring BEER and PIZZA...I am not looking for someone to do it for me..just someone with tools, a place to do it, and knowledge.
 

·
I am the law.
Joined
·
29,823 Posts

·
Registered
Joined
·
680 Posts
Discussion Starter · #13 ·
GREAT write-up on doing it....now all I need are pretty much every tool he mentions. :( :( :( :( :(
 

·
Stick it up your ass
Joined
·
3,071 Posts
Just remember: 13mm, 12-point as it says in step #5. Don't try anything else unless the factory bolts have already been replaced with something else. You'll strip the heads and then you'll be fucked.

x2 on the 13mm 12 point socket. Just ask ddeadserious.
 
1 - 16 of 16 Posts
Top