Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 7 of 7 Posts

· Registered
82 Posts
Discussion Starter · #1 ·
Here are some things I've been wanting to get out of my shop / Best Offer:

Metal sun Approx 12", 1/8 thick steel. $10

5 Gallons Behr Fence and Barn Paint Latex/Oil. Unopened. Paid $80, asking $50

Fluorescent Light Ballast for 4ft fixtures $5

Wagner Paint Sprayer. I should have most of the pieces. Stopped working on me and I never bothered cleaning it. As-IS don't know anything more about it. $10

Brother Fax Machine. Bought used, never tried it out. I have the phone piece but no phone cord. $5

Avery Dwell Angle / Tachometer. Untested. $10

4 U-Bolts and plates. Bolts measure 3 5/8 x 7 1/2 with 9/16 fine thread. $10

3 Sheets 1/8" plexiglass. Replacements for sandblaster I no longer own. 21 1/2 x 10. $5

Water Pump Assembly for Metal Bandsaw. I have 3 of them. $25. Also have a couple gallons of water soluble bandsaw lubricant, $10

4" angle magnets new in box. $5 for the pair

Conduit Bender for 3/4" EMT. Barely used. $20.

8 x 3 3/4 rims, 4 on 4" bolt pattern $10

2 used castor wheels 4.5" - $10

Central Hydraulics Air/Hydraulic 18" Rams. The air pumps were beyond repair and have been plugged. Still work as regular bottle jacks. $40 ea.

Hydraulic Pipe Bender. I suppose if you had enough patience you could make some decent bends. Only tried it once or twice, mostly just used the bottle Jack. $50

Craftsman 6" belt sander. Works fine, bought used and never had a need for it. The stand could use a couple bolts tightened. Someone before me did a half/ass job of adding some shopping cart wheels? $50

Roller Stand for Bandsaw. $5. Water Pump for Bandsaw $25

7 x 12 Bandsaw. Needs work. I have most of the parts. Will need replacement blade guide assembly, possibly some bearings, and one of the wheels wobbles on the gearbox shaft which throws the blades off. $200

Rack roughly 2' x 4' x 4 or 5' tall. Three shelves welded into place. $20

Truck Bedliner. Came out of 1990 GMC Extended Cab Short Box. I also have the tailgate protector. No idea what else this fits, please don't ask I really don't know. Some rust stains, might clean up. $10

CJ-5 Doors. I recommend you have the ability to cut/weld as these need some work. I think I have most of the parts including glass. I don't think I have the window crank knobs. $40

Plastic Chain, 3/8 link, two 25ft pieces. I paid a hundred bucks for this stuff. $25

XJ Roof Rack, all mounting hardware included. Single piece rack measuring 6 x 4. $250

Air/Cut-off Tool with 10 wheels. Did not work as well as I had hoped. but would probably work fine on sheet metal if you're patient. $10

Stainless Steel TIG Rod, 1/8" x 36". About half a box. I don't weld stainless anymore. $20

Chest Freezer, would not fit through my basement door so it has been sitting at my shop since last summer. I paid $75 I'll take $40.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.