Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 6 of 6 Posts

·
broken
Joined
·
5,093 Posts
Discussion Starter · #1 ·
well they didn't turn out exactly how i pictured :sonicjay: i chose the measure once and cut 10 times method.
started with a bunk bed slide 3/16 cut them so they go all the way to wheel wells and don't stop at the flairs.
 

Attachments

·
broken
Joined
·
5,093 Posts
Discussion Starter · #2 ·
next i was going to bend some tube,but failed real bad . so i went with 2x2 square.
not perfect but it will work. i think
 

Attachments

·
broken
Joined
·
5,093 Posts
Discussion Starter · #4 ·
thanks
 

·
broken
Joined
·
5,093 Posts
Discussion Starter · #6 ·
all done! (for now) i must say it looks ok for a bunk bed slide and parts rack :sonicjay:
 

Attachments

1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top