Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5,407 Posts
Discussion Starter · #1 ·
Bill or others.......

I am putting back together my D60 this morning after replacing the wheel bearings. Does anyone know the procedure / torque specs for setting the correct wheel bearing preload on a 1978 F350 Dana 60 front?

I have searched google and found nothing. Thanks.
 

·
Yankabilly
Joined
·
7,944 Posts
sorry so late but better than never...

I torque the inner nut to 45 ft lbs and back the nut off a 1/4 turn. Then install the flat washer with holes in it , or the one with spider legs. Than I torque the outer to 60 ft lbs.
 

·
Registered
Joined
·
5,407 Posts
Discussion Starter · #3 ·
Thanks Bill. I found some D60 manuals on Pirate that said 50 - 1/4 turn and 50 for the lock nut so I went with that.
 
1 - 3 of 3 Posts
Top