Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 9 of 9 Posts

4,117 Posts
pass over everything with 6010 5p+
then run over that with 7018 lhr
with a dc stick welder.
the 7018 has to be run uphill or flat.

have the gears tacked while axles still in them to make sure the welding dosnt pull the side gears out of alinement. no need to pre heat when 60105p
+ is used first

if he is going to do it with an ac welder with no fine tuneing or a mig/fluxcore dont have them do it, and find a qual. welder with a dc rig.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.