Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,339 Posts
Discussion Starter · #1 ·
I had a craked exhuast manifold and torn motor mounts...
But not any more.

Took some photos for referances...Incase I bump my head and forget where things go...




Old vs new mounts... These new ones are good and stout



Why I opted to do the mounts at the same time...It was just too easy getting to the mounts with the intake and exhaust off.



Close up of the mount...



New vs Old... The new is Edelbrock Ceramic Coated



All and all not too bad of a project but there were times that I could have used an extra set of fingers or extra set of hands.


I did both mounts but just did not take any pictures of the right hand mount... It was pretty much an no event.
 

·
Registered
Joined
·
1,339 Posts
Discussion Starter · #4 ·
Do I even want to know what the stick is for in pic 3, 97xj?
It is a general tapit and wackit stick. I can not remember why I had it out.

It is half of a spare railing spindles that was left over from a deck build several years ago.
 
1 - 7 of 7 Posts
Top