Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 16 of 16 Posts

·
FULL WIDTH
Joined
·
151 Posts
Discussion Starter · #1 ·
I have a 120volt wall chager for my dogs e-collar (tri-tronics) and it wont charge the batteries. The output of the charger is 9v 350mA. I hooked up my multimeter and probed the inside and outside of the wall charger's end and only got 0.145V. Is there a different way you guys know of to test a 9Volt wall charger??
 

·
Old School
Joined
·
33,047 Posts
I have a 120volt wall chager for my dogs e-collar (tri-tronics) and it wont charge the batteries. The output of the charger is 9v 350mA. I hooked up my multimeter and probed the inside and outside of the wall charger's end and only got 0.145V. Is there a different way you guys know of to test a 9Volt wall charger??


It's Dead, Jim.
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top