Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 6 of 6 Posts

·
No more Jeep
Joined
·
4,008 Posts
Discussion Starter #1
Any body have info on this.

I saw a thing on it a wile ago but i think it was off the M J site.

Just looking i guess. any one has done it seen a How To on it let me know.
 

·
Mall Rated
Joined
·
1,567 Posts
I did a cable set up for twin stick in a 300 that was put into a TJ. Allows you to put the sticks in different locations than coming up through the passenger floor board.
 

·
Premium Member
Joined
·
9,000 Posts
I can try and snap pics of my linkages next time mine is in the shop. They are pretty straightforward.

I based mine on this image.
But I bent two 1/4" pieces of plate that fit in the inside of the shifter fork instead of using stock shifters. I just welded ball bearings to the bottom of the plates to fit into the holes on that plates that attach to the shifter rods.



Not sure if that makes sense.

 

·
Resident HVAC/R Jambi
Joined
·
10,939 Posts
Yeah, I made my own also. Kinda similar to that pic Monkey posted, but withouth the round pipe part on it. I would like to redo mine, because on the freeway the sticks rattle like mad and drive me crazy! The one I made, I used 2 stock D300 sticks and then those little plates on the shift forks to make it work.
 

·
Dopey
Joined
·
1,362 Posts
in the picture that monkeyevil posted, which shaft is for the front and which one is for the rear?
 
1 - 6 of 6 Posts
Top