Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 11 of 11 Posts

·
Registered
Joined
·
241 Posts
Discussion Starter · #1 · (Edited)
I have a disassembled ford 302 engine I need to get rid off. The block is machined to 4.040" bore so technically the engine is now a 308 cu. in. The engine has set for awhile so the cylinders need to honed before being assembled. Heads are from a good running stock 87 mustang GT. The pistons are Speed Pro - forged pistons. If you were to assemble the engine you would definitely have to have the crank machined or buy new (new crank is $150-$200). The block is an older non-roller style block buy I do have a used roller setup (minus lifters) that goes with the engine. I also have the bearings and the gaskets to assemble the engine. The gaskets and bearings alone were $120. For less than an addtional $300 someone could have a running engine.

Pistons alone sell for $327 new.

http://store.summitracing.com/partdetail.asp?part=TRW-8KL2482F40&autoview=sku

Location: Allegan, MI

Price $200 takes it all.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top