Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 3 of 3 Posts

· Registered
Joined
·
122 Posts
Discussion Starter · #1 ·
I am installing a IRO 4" lift on my 98 Cherokee, purchased a new stock drag link since doth ends were trashed. I have searched online and no one gives a straight forward answer... Should the drag link be adjusted to stock length or what should the geometry be from the pitman arm to axle?


Sent from my iPhone using Tapatalk
 

· Registered
Joined
·
122 Posts
Discussion Starter · #3 ·
set toe with the tie rod first.

then adjust the drag link to align the steering wheel.



adjusting your new drag link to what your last one was at will give you a starting point, but will need adjustment from there.

Thank you, that's kinda what I ended up doing. Helps that I purchased a drop pitman arm


Sent from my iPhone using Tapatalk
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top