Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 2 of 2 Posts

·
The DUKE
Joined
·
452 Posts
Discussion Starter · #1 ·
I have a dana 44 high pinion front axle and a ford 9" rear axle that I had purchased to swap into my jeep but have since used different axles. These axles are out of a 79 bronco not sure on the gearing I would assume 3.55 or 3.73 but I have not checked. The front axle has the case tubes on it. I have cut off one of the knuckles on for the radius arms as seen in the pictures. This could be patched or do the extreme 4x4 thing and put new tubes on it. If you have any questions please feel free to ask and I will respond ASAP. I am located in zip 48117 about 2 miles from where I-75 & I-275 meet. 734-497-1530 $300 for the pair
 

Attachments

1 - 2 of 2 Posts
Top