Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
625 Posts
Discussion Starter · #1 ·


I currently have ipe/Brazilian walnut (pictured left in semi gloss), curly cherry (pictured right with a cherry stain in a gloss finish), padauk, domestic walnut, and zebra wood material on hand.

These are designed to fit all 1911s with the exception of bobtail models or ambi safety models. They are a perfect fit with countersunk screw holes and countersunk grip bushing holes on the back side. They are cnc machined and I also set up a jig on my laser engraver for engraving.

$50 per set for any of the materials I have listed, $20 per set to engrave, free pickup in St Clair Shores or $6 shipping anywhere in the USA
 

·
Premium Member
Joined
·
625 Posts
Discussion Starter · #3 ·
I attempted checkering with a 30* bit but there was a lot of tear out. I'm going to design a checkered pattern and give it a shot with the laser engraver and see how it turns out
 
1 - 6 of 6 Posts
Top