Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 1 of 1 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter · #1 · (Edited)
I have a plow setup for a CJ. The blade is a 6ft blade (I think) and it does have the ability to shift side to side, but I do not have the hydraulic cylinders to make this feature work. I have the blade, the pump (which would allow you to install side to side cylinders), one good set of lights, one bad set of lights, and two sets of mounting brackets, and I think I have the switch laying around somewhere in my garage. I have never had this installed on my jeep, it was on a parts vehicle that I bought. I was told that it works, and I suppose it would (just simple hydraulics right?) I am not looking to make a fortune, just trying to recoup some money from the parts vehicle (and keep the wife happy by getting it out of the yard). $200 OBO

Note: I have no way to deliver this. You must pick up, and it is very heavy!!!

E-mail to: [email protected]

I do not check my PM's that often so send me an E-mail please, thanks for looking
 

Attachments

1 - 1 of 1 Posts
Top