Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 9 of 9 Posts

·
Yooper In Training
Joined
·
7,248 Posts
Discussion Starter · #1 ·
I've got a tool I made to turn the threaded adjusters on a Chrysler 8.25" rear axle. Anybody who's ever had the carrier out will know what I'm talking about.....you need this to tighten the adjusters and set the backlash. Made out of black pipe with a large nut on the end that fits perfectly in the adjusters. $20 obo, located in Highland.



 

·
Registered
Joined
·
4 Posts
Chrysler 8.25 Carrier Adj Tool

Interested if you're willing to ship it to me, of course I'll pay for that.
I'm in Nunica, between Grand Rapids and Muskegon.
 

·
Yooper In Training
Joined
·
7,248 Posts
Discussion Starter · #3 ·
I'll ship it, but it'll probably be at least $20 due to size.
 

·
Registered
Joined
·
7,150 Posts
dont the 9.25 use the same tool... ??????? if so i could use it.
 

·
Yooper In Training
Joined
·
7,248 Posts
Discussion Starter · #9 ·
dont the 9.25 use the same tool... ??????? if so i could use it.
I honestly don't know, I've never had the 9.25 apart. If it's got the threaded adjusters and you know what size hex they are I can measure mine to see if it's the same.
 
1 - 9 of 9 Posts
Top