Great Lakes 4x4. The largest offroad forum in the Midwest banner

chevy dana 60 and 14 bolt ff 4.10

3051 Views 29 Replies 14 Participants Last post by  BenAbraham
nice chevy dana 60 front axle painted with black epoxy paint, new kingpins(all genuine parts from gm dealer), warn supreme hubs , valvoline synthetic grease in kingpins and bearings

14 bolt full floater rear axle, new brakes (shoes, turn drums, hardware, wheel cylinders), new axle seals and pinion seal

both axles from low mileage truck about 50,000 miles and very clean inside

$1500 for both firm

(989)666-7315 no calls after 10 pm and NO TEXTS


See less See more
1 - 9 of 30 Posts
lmao, i think ill put them under my creeper. thanks for the bump
sorry, price is firm. these are very nice and well worth 1500.
nope, just good clean low mileage axles that come with pretty much everything new. they have less than 4,000 miles since all brakes and seals, king pins and warn lockouts. im new to this site but ive been playing with dana 60s for a while and most guys sell worn out axles that need $1000 or more put into them for a grand. dont agree? dont have too, if they dont sell theyll go under a future truck project. just trying to help somebody out for the time beeing that just wants to bolt up and go.
good deal, but ive owned several of these trucks, and most times the gears are rust from fluid level up, the kingpins are junk, the hubs are full of rust. not to mention the seals are bad from sitting, the wheel cylinders blow out right away. so there you are putting $$$$$$ into the great deal. it adds up fast on these axles

not saying i wouldnt buy another one,

but these axles are READY TO GO.
Ok, i am also new-ish to this site. But im pretty sure that if he wants $1500 for them its his choice, and everyone else should just leave it alone. Its this kind of crap that makes me not want to sell anything on this site as well. 1ton, i would take the axles somewhere else where people appreciate what they are, and will pay the price cause they know what there worth.
thank you, i just figure it only takes one reasonable person to want them.
Just asking, are you comparing a dana 60 of unkown condition to a matching set of complete gone through front and rear axles?
hes comparing a 79 ford axle
1 - 9 of 30 Posts