Great Lakes 4x4. The largest offroad forum in the Midwest banner
1 - 20 of 56 Posts

· Registered
Joined
·
7,150 Posts
Discussion Starter · #1 · (Edited)
This is a home built Car Trailer 16 FT Long. The trailer has 2 3500 Lbs axles with brake not wired up. The trailer has new led tail lights with fresh new wiring, fold up trailer ramps, and 4 decent tires. Also has two new fenders have been installed.

$850 obo
 

· Simplify...
Joined
·
8,243 Posts
whats the width in between the wheel wells? might be interested let me know thanks
wally
Sorry i forgot about my post.

i dont really have in wheel well measurements. Because there is no fenders on it right now.


Bump
I would think that it would be helpful to measure outside-to-outside on the frame rails at the wheels, and subtract ~1/8" for the thickness of the fenders that would be there.

Craig
 

· Registered
Joined
·
7,150 Posts
Discussion Starter · #7 ·
I would think that it would be helpful to measure outside-to-outside on the frame rails at the wheels, and subtract ~1/8" for the thickness of the fenders that would be there.

Craig
When i get a chance i will get a messurment but the trail is wide enough for full width if you drive over the fenders.
 
1 - 20 of 56 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top