Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 15 of 15 Posts

·
Registered
Joined
·
952 Posts
Discussion Starter #1 (Edited)
"Built" bolt- in ready Jeep TJ axles and 35" KM2' on beadlocks

Considering selling the axles out of my TJ to run a one ton setup. These are in my 99 Jeep Wrangler and will bolt into any TJ with stock styled suspension

Front:
HP Dana 30
Artec front full truss
Yukon 4.10 gears
Yukon chromo shafts
HD ball joints
Yukon locker,
HD axle shaft seals
Gusseted axle c's
Spicer axle joints

Rear:
Ford 8.8
Yukon 4.10 gears
Spool
Rear TJ conversion
Yoke setup for TJ driveshaft
Needs one axle seal

1 ton steering with heim joints included (tie rod and drag link)
PSC hydro assist pictured will not go

(4) 35x12.5x15 BFG KM2's with GREAT tread. A little rock rash and not perfectly wore for the very few road miles this jeep has seen. All road miles were from camp grounds to silver lake dunes entrance.

Mounted on DIY beadlocks with fresh outside paint. A few bolts missing where they got snapped but hold air great. 12oz of airsoft bb's in each wheel to balance. Match grade not the biodegradable bb's.

I also have one spare 33x12.5 on a DIY beadlock wheel that I will include as well. Holds air long enough to get off of the trail. I have never needed it but always brought it along.

For full asking price I've got a spare rear shaft and probably 3 sets of front inners, outters, and joints ready to replace if needed (I never have). I also have new in box Spicer axle joints I can throw in too.

Package deal $3,000. I will split up wheels/tires from the axles ONLY if the axle setup sells first. I will not sell the wheels and tires before the axles.

Located in 49094. I will not be able to pull these until Feb 8th at the earliest (when I pick up the 1 tons).




Sent from my SM-G973U using Tapatalk
 

·
Registered
Joined
·
952 Posts
Discussion Starter #2
May consider partial trades for an 18'+ car hauler for the jeep. I dont think it is but if my price is way off let me know

Sent from my SM-G973U using Tapatalk
 

·
Registered
Joined
·
952 Posts
Discussion Starter #5
What locker specifically in the front? Interested in selling just the rear?


Front Yukon Grizzly locker I believe. Eh may consider splitting them but it would have to be a decent price. Always harder to sell individually. Front is already out and good to go rear will be a little bit yet.

Sent from my SM-G973U using Tapatalk
 

·
Xj 4 Life!
Joined
·
398 Posts
Bump. Am I asking too much?

Sent from my SM-G973U using Tapatalk
I don't think that you're asking to much. It's just that most of the people on the forum anymore already have built axles, and there isn't a lot of new members joining the forum. I would still keep it up on the forum and active, but you may get a better response on Facebook marketplace or Craigslist.

Good luck selling them.
 

·
Registered
Joined
·
952 Posts
Discussion Starter #10
1750 or trade for nice trailer. Ideally a wider deckover but I can always fab up some drive over fenders. 18'+ no mobile home axles

Sent from my SM-G973U using Tapatalk
 

·
Registered
Joined
·
952 Posts
Discussion Starter #12
Bump may trade towards quad, golf cart, UTV, mini bikes, etc. Partial trades considered, can add cash for right deal

Sent from my SM-G973U using Tapatalk
 
1 - 15 of 15 Posts
Top