Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1 (Edited)
500 CID Cadillac engine with intake, exhaust manifolds, bellhousing, Accel electronic fuel injection, aluminum radiator, alternator and starter runs great. Remanufactured engine has been used for an industrial purpose the last 10 years, is mounted on a stand and is inside an enclosed trailer. The engine has only about 500-600 hours or 30,000 equivalent miles on it from running a vacuum pump and would run at 2,000 to 3,000 RPMs for 6-8 hrs at a time. I no longer need it and thought it would make a great engine for a Jeep, old Blazer, suburban, pickup or even a Chevette. Can hear it run still mounted in trailer, engine stand come with it. $2,500 or offer. Marked down to $1800 or trade
Located in west Branch, MI
 

·
Registered
Joined
·
783 Posts
What is horsepower and torque of this motor? My jeep has a 400 turbo it would be easy to find a Buick Olds Cadillac 400 turbo to bolt this together.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
What is horsepower and torque of this motor? My jeep has a 400 turbo it would be easy to find a Buick Olds Cadillac 400 turbo to bolt this together.
Not sure exactly but found this information on the engine
500 cu in (8.2 L)
365 hp (272 kW) @ 4400 rpm
535 lb⋅ft (725 N⋅m) @ 2800 rpm
4.3 in × 4.304 in (109.2 mm × 109.3 mm)

Over 500 ft lbs of torque that would be a lot of fun!
 

·
Registered
Joined
·
89 Posts
A fuel injected 500 inch Caddy in a older full size Chevy? That would be badass! Imagine this thing in a early 70s Blazer.
 
1 - 9 of 9 Posts
Top