Great Lakes 4x4. The largest offroad forum in the Midwest banner

1 - 20 of 20 Posts

·
I have an avatar. Yippee.
Joined
·
4,280 Posts
Discussion Starter #1 (Edited)
Parts removed from my 2006 LJ Rubicon 6spd that spent it's life in Texas and Kentucky before I brought it to MI last December.

Parts are located in New Boston (~6 miles south of DTW), I work in Ann Arbor. Paypal accepted. Shipping via FedEx ground or home, or USPS available.

Rear bumper w/ ends painted in black textured bedliner, $20

Transmission cross member/skid plate w/ manual NSG370 bracket and Rubicon pump mounting bracket $40

OEM rear defrost switch $5

OEM rear wiper switch $5

Fel-Pro BS-40183 rear main seal set- new, unused, includes paper seal guide $10



Napa clutch pilot bearing, part number FC69907 $5
 

·
I have an avatar. Yippee.
Joined
·
4,280 Posts
Discussion Starter #7
This is the only pic I have of the skid plate. This is how it looked when I removed it for the flat belly install. I bought the Jeep in Kentucky, but it spent most if its life in Texas. The Jeep was someone's daily driver and not a off-road toy- no trail pinstripes and the PO put on Yartu street tires on it. The other side isn't painted but expect normal "preservation substances" as it is a Jeep.


 

·
I have an avatar. Yippee.
Joined
·
4,280 Posts
Discussion Starter #8 (Edited)
JKS #03001 transfer case shift lever drop bracket $1.00 or trade for Arizona Tea "Energy" flavor






Kilby air filter x2 and dipstick for York 210 air compressor. Two filter elements are sealed in the factory back. Dipstick is the bent wire also sold by Kilby (years ago). $10



Dorman 711-221 1/2"-20 Acorn Wheel Locks. New in pack, four locks in pack, key included. $10




Things I'm interested for trade:
- a clean CJ tailgate
 
1 - 20 of 20 Posts
Top