Search Results for ‘cj7’

Fully restored (frame off) 1983 Jeep CJ7. My personal vehicle and project. 4.2 Liter , 6 cylinder original motor had 52000 miles when purchased. (has 3800 on the new digital speedometer) Front fenders, grill, windshield replaced with used parts. It has a 1992 Jeep Safari galvanized tub in...

It is with a heavy sigh and sad heart that I finally give in to my busy life and try to find a better owner for my beloved CJ. Been a great project for many years, and I feel like I've built a pretty solid rig. It sadly lived on the streets as much as it is built to handle trails, but have a...

After 21 years it's time to sell. New JL Rubicon is on the way. There's not much that i have not touched on this Jeep. Runs great. Goes down the road straight and true. asking $19,500 obo. 1983 Jeep CJ7 Body and Interior 1995 YJ Wrangler Tub, windshield, wipers, dash, heater, roll bar Floor...

I am looking for a set of axles for my 85 CJ7 with gears between 3.55 and 4.11 to use as an upgrade from my current 2.73's. I figure I I see what is available before buying gears, carriers and shafts for my current axles. If you have upgrade parts I am also interested. If you are looking...

Anybody looking to buy a summer toy...1976 Jeep CJ7. Completely rebuilt AMC 360 motor, 4-10 gears, B&M ratchet/slam shifter, front and rear positraction. It's sitting on 33" Firestone tires with very few miles on them. Fiberglass body and 5 point harness. My dad custom made this Jeep and he...

I have a CJ7 top with all windows and fiberglass in great shape, no cracks and two doors. Doors windows are good and roll up and down. Stored inside and for the ground. :woot: $900.00 tacks it all 269-209-5808 Tim

I have a set of 4 wheels and tires. $150.00 for all 269-209-5808 Tim

CJ-7 with 350 SBC. Headers, edelbrock intake, RV cam, holley 600 carb, th350 trans, 205 t-case, ratchet shifter, K5 Blazer Axles, hard top, steel doors, BFG's. Tons of extras - extra doors, winch bumper (not pictured), new windshield (not pictured), extra body parts, extra t-case. Also...

Driver side drop Dana 60 Kingpin professionally built front axle with the tubes rotated to keep driving manners perfect at highway speeds. Full high steer kit with Chevy tie rod ends to keep it street legal. Built with all new bearings, seals, and Richmond 5.38 ring and pinions with Detroit...

CJ-7 hard top, no back with it. 2 full hard doors. 400.00

I may or may not have had a beer (or six :beerbang: ) and decided to dump the clutch in my '80 CJ7 while in reverse. That said, I'm looking for a t176 trans as I'm pretty sure that's what in it, haven't had the time to start tearing down because I've been busy sulking. :chauncy: Also a solid YJ...

Fiberglass front fenders and hood for CJ-7. $200 i have steel tub, door opening back is rough, but the front part is not bad. $50 Hard top with back door, rusted, but the glass is still good. $150 :usa:

I am selling my 1978 Jeep CJ7. This jeep has had a lot of work done to it and runs and drives great. The engine is a built GM 350 that has been supercharged and dynoed at 435 hp! Don't trust the other guys that say they have 400hp, see the dyno sheet and feel the pull on this jeep when you drive...

I have a 85 CJ7 with 77xxx miles on it for sale. this was a project viecial for my son and myslef. He is going away to school and it is not practical for him to take it. Plus the money could help!!! We have had it for almost 3 years now and done a fair amount of work on it. It will need body...

I have a 85 CJ7 that crashed yesterday...... tub damage only. looking to replace with steel or aluminum tub. Thanks :usa:

$8250 http://saginaw.craigslist.org/cto/3641447061.html Turn key fun in the summer sun or snow. Starts easy, drives smooth, trouble free toy or daily driver. Frame off restored in 2004, fiberglass body, wiring harness, everything rebuilt or replaced Jeep CJ7 Yellow LineX coated exterior...

Looking for used but still functional leaf springs. Either (4) 2.5" lift springs (2" wide fronts and 2.5" wide rears or (2) rear stock in the 6 leaf configuration. Thanks

https://plus.google.com/u/0/photos/106399187730779601656/albums/5636450698602654033/5636451141194037026?authkey=CJit29zIz-ulYA Fiberglass tub with 1-piece front clip AMC 401 V8 Turbo 400 auto transmission Quadra-trac transfer case 8"Spring over Lift Dana 44 Axles 4.88 gears - front and rear...

http://grandrapids.craigslist.org/cto/2983235561.html Fiberglass tub with 1-piece front clip AMC 401 V8 Turbo 400 auto transmission Quadra-trac transfer case 8"Spring over Lift Dana 44 Axles 4.88 gears - front and rear Detroit lockers Aluminum Be Cool radiator Pit Bull Rocker Bias Tires -...

This Jeep has been a project planned for the winter... the last 2 winters, now I need the room and cash so it's got to go. http://nmi.craigslist.org/pts/2985443164.html Specs are as follows: 1978 Jeep CJ7 Engine: GM 350 V8 Carb - Edelbrock Performer 600 Intake - Edelbrock Performer...