Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - '81-'87 Chevy/GMC squarebody truck sheetmetal and parts
View Single Post
Old September 9th, 2018, 07:12 PM   #1
Hang all the thieves
Join Date: 07-12-11
Location: Davison
Posts: 1,859
iTrader: (3)
Mentioned: 1 Post(s)
Default '81-'87 Chevy/GMC squarebody truck sheetmetal and parts

Cleaning out the garage. Need to find new homes for a lot of parts.

Rust free bed floor for an 8' box. Came from Texas, was a work truck. Lots of dings and bumps in the bed floor, but it is original GM metal and completely rust free. I shot epoxy primer over the top to seal and protect it after I wire wheeled all the old loose paint off. $350. **SOLD**

Another bed floor, also from an 8' box, also a southern truck. Needs the rear section of the floor replaced, as it was a fire truck, and they had a steel plate over the last third of the floor, and the chemicals corroded the floor under the plate.
Cross braces are rust free and unaffected. Very few dings or dents in the forward portion of the floor. $150

2 box fronts for fleetside trucks, good condition. $50 each** 1 SOLD**

Box sides for 8' fleetside box. Drivers side fuel fill. Both were from a southern truck and have no rust, except for some surface pitting where they were bolted to the red floor.

Drivers side had a large area of plastic filler that was starting to pop, so I ground it out. No rust damage, but it was straightened from some body damage. This is the area that is primered in the pics. $250**SOLD**

Passenger side looks good, clean rust free as the other side, but doesn't appear to have anywhere near the amount of filler that the drivers side did. $400**SOLD**

Hood. Has a couple of small dings in the center character line, otherwise no other damage. Rust free original GM metal. $50

Factory A/C system. Not sure what parts may be reusable, but it's all there. $40 for all of it**SOLD**

2 cowl panels from '81 to '87 body style. Rust free. Not bent. $25 each.**1 SOLD** 1 Remaining

Bench seat, from '81 to '87 truck. Good shape, nice foam, better than most underneath. Could use a new cover, gray in color. $100**SOLD**

Tailgate. GMC. drilled for High Sierra/ Silverado trim band. Clean, nice condition, rust free. No dents or dings. $200**SOLD**

Not pictured

Dark brown interior, door panels, velour seat cover trim and headliner from a Silverado truck. Headliner has been recovered. Driver quality condition on the trim and door panels. $200**SOLD**

Rear fleetside wheel wells, rust free, GM metal. $30 apiece or $50 a pair. Have 2 pair.

Front bumper. '81 to '87 style. Has plastic air dam still attached. Was on a 4wd truck. Not bent, still looks nice driver quality. $50**SOLD**

I will get some pics up tomorrow.

Last edited by CSFJ; July 4th, 2019 at 10:12 PM.
CSFJ is offline   Reply With Quote
Page generated in 0.45639 seconds with 24 queries