Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Amc 360
Thread: Amc 360
View Single Post
Old April 27th, 2019, 02:30 PM   #1
Bronco2xj
Senior Member
 
Join Date: 10-06-16
Location: Roseville michigan
Posts: 144
iTrader: (0)
Mentioned: 2 Post(s)
Default Amc 360

Started to rebuild a 360 for a wagoneer. Decided Iím going a different route. The block has been bake, blasted, and decked. The 7th cylinder was bored and sleeved due to porosity. It is already .030 over and still needs to be honed .040 over for pistons. The heads were also baked and blasted. But still need new guides installed. The exhaust guides have already been knocked out but new ones need to be installed. Intake guides were knurled and reamed but I was going to just ream them and put in new ones. The crank is .010 undersized on all journals. The mains are straight and didnít need any work. The block was fluxed and pressure tested for cracks, so were the heads. No cracks were found. Asking for $400 obo. Or will trade for a set of 35x12.5 R15. I have pictures. If desired just text me 586-244-7259. Thank you.
Bronco2xj is offline   Reply With Quote
 
Page generated in 0.12004 seconds with 24 queries