Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Dirthead 509" TJ Project
View Single Post
Old February 16th, 2009, 05:17 PM   #78
feva4u's Avatar
Join Date: 04-01-07
Location: Caledonia, MI
Posts: 10,942
iTrader: (12)
Mentioned: 22 Post(s)

Had an oversight while making brackets, need to put my JJ's for the front lower links on the frame side and designed my brackets for the JJ's to be at the axle side. Width's are the same but the poly sides are 2.0" dia vs the 2.5" dia of the JJ's. Going to have to "fix" my frame side brackets to accept the JJ's instead of the poly.....

Found pic, going to need clearance in the brackets to the JJ's fit.
My plan:

Bolt hole centerline is 1.5" from the top and the mat'l is .25" so I'll just have interference with the mat'l depending on how accurately I placed the hole. With the clearance cut I don't think it'll be an issue. Just going to look a little booty with the notches but I think I'll be ok.
feva4u is offline   Reply With Quote
Page generated in 0.39066 seconds with 24 queries