I thought aluminum rims were supposed to stick to steel hubs? - Page 2 - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > General 4x4 Stuff > The Pub
GL4x4 Live! GL4x4 Casino

The Pub A friendly forum where everybody is nice, and will answer any questions you have about life.

greatlakes4x4.com is the premier Great Lakes 4x4 Forum on the internet. Registered Users do not see the above ads.
Search
Reply
 
Thread Tools Search this Thread
Old January 5th, 2008, 07:25 PM   #21
bigcountrysg
Countryboy
 
bigcountrysg's Avatar
 
Join Date: 05-07-07
Location: Willis Michigan
Posts: 1,599
iTrader: (3)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by unclebeaner View Post
i think we need to have a junkyard challenge to settle this
I already challenged PP. He turned it down. He never replied to taking the challenge.

The challenge was to start a car that was equiped with an automatic transmission by pulling it to speed or by pushing it to speed. I even laid out a small wager. But yet he refused to take that challenge.

Maybe he refused my challenge because he can't even properly put a tire on a vehicle.
bigcountrysg is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old January 5th, 2008, 07:25 PM   #22
PavementPounder
I am the law.
 
PavementPounder's Avatar
 
Join Date: 11-05-05
Location: Birmingham, Michigan 48009
Posts: 29,824
iTrader: (224)
Mentioned: 2 Post(s)
Default

I didn't put the front wheels on, BigCunt.

And I don't question your ability to turn a wrench. I just think you aren't smart and are incapable of learning since you continue to assume you know everything about every situation, even after being taught that lesson over and over again. Its not my fault you were wrong about push-starting automatics, even after facts and explanations were provided. Get over it.

You will never be a challenge to me, because I don't care.
PavementPounder is offline   Reply With Quote
Old January 5th, 2008, 07:29 PM   #23
unclebeaner
can you hear the banjos?
 
unclebeaner's Avatar
 
Join Date: 04-04-06
Location: Flat Rock 48134
Posts: 9,069
iTrader: (72)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by PavementPounder View Post
I didn't put the front wheels on, BigCunt.

And I don't question your ability to turn a wrench. I just think you aren't smart and are incapable of learning since you continue to assume you know everything about every situation, even after being taught that lesson over and over again. Its not my fault you were wrong about push-starting automatics, even after facts and explanations were provided. Get over it.

You will never be a challenge to me, because I don't care.
push starting auto's eh? im gonna go try that right now.





if it come to cage match 50 on pp he looks ferice in person
unclebeaner is offline   Reply With Quote
Old January 5th, 2008, 07:30 PM   #24
bigcountrysg
Countryboy
 
bigcountrysg's Avatar
 
Join Date: 05-07-07
Location: Willis Michigan
Posts: 1,599
iTrader: (3)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by PavementPounder View Post
I didn't put the front wheels on, BigCunt.

And I don't question your ability to turn a wrench. I just think you aren't smart and are incapable of learning since you continue to assume you know everything about every situation, even after being taught that lesson over and over again. Its not my fault you were wrong about push-starting automatics, even after facts and explanations were provided. Get over it.
I am not incapable of learning. Because if I was I would not know everything I know now.

Yes there are kits out there that allow you to push start an automatic. Yes there were automatic transmissions that were once made. That allowed you to push start an automatic.

But my challenge still is open. Because unless you have that old school trans or a modified trans. Your not going to push start or pull start an automatic. Remember my challenge was for an oem trans. So a modified one would not be allowed for this challenge.

I don't assume that I know everything. You assume that.
bigcountrysg is offline   Reply With Quote
Old January 5th, 2008, 07:30 PM   #25
mideerslayer
NEVER GIVE UP!
 
mideerslayer's Avatar
 
Join Date: 04-27-06
Location: Clinton Township
Posts: 3,837
iTrader: (29)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by PavementPounder View Post
And I don't question your ability to turn a wrench. I just think you aren't smart and are incapable of learning since you continue to assume you know everything about every situation, even after being taught that lesson over and over again.
Now that is funny right there
mideerslayer is offline   Reply With Quote
Old January 5th, 2008, 07:32 PM   #26
mideerslayer
NEVER GIVE UP!
 
mideerslayer's Avatar
 
Join Date: 04-27-06
Location: Clinton Township
Posts: 3,837
iTrader: (29)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by unclebeaner View Post
i think we need to have a junkyard challenge to settle this

Ill bring the pabst Blue ribbon
mideerslayer is offline   Reply With Quote
Old January 5th, 2008, 07:34 PM   #27
junk90xj
ALLPRO AUTO
 
junk90xj's Avatar
 
Join Date: 11-06-05
Location: lansing
Posts: 4,550
iTrader: (47)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by bigcountrysg View Post
To think you question my ability to turn a wrench. Your such a joke. In my 18 years of wrenching I have never had a tire fall off.

I think you need to keep your wrenching comments to yourself from now on.
you should shut you mouth.
__________________
http://www.apalansing.com/
junk90xj is offline   Reply With Quote
Old January 5th, 2008, 07:36 PM   #28
71jeepster
Glad I'm not Gay J. Hall!
 
71jeepster's Avatar
 
Join Date: 09-26-06
Location: Kellogg, ID
Posts: 3,091
iTrader: (12)
Mentioned: 0 Post(s)
Send a message via Yahoo to 71jeepster
Default

Quote:
Originally Posted by unclebeaner View Post
i think we need to have a junkyard challenge to settle this
that would make a great youtube video!!
71jeepster is offline   Reply With Quote
Old January 5th, 2008, 07:36 PM   #29
unclebeaner
can you hear the banjos?
 
unclebeaner's Avatar
 
Join Date: 04-04-06
Location: Flat Rock 48134
Posts: 9,069
iTrader: (72)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by junk90xj View Post
you should shut you mouth.
BURN
unclebeaner is offline   Reply With Quote
Old January 5th, 2008, 07:46 PM   #30
PavementPounder
I am the law.
 
PavementPounder's Avatar
 
Join Date: 11-05-05
Location: Birmingham, Michigan 48009
Posts: 29,824
iTrader: (224)
Mentioned: 2 Post(s)
Default

Quote:
Originally Posted by bigcountrysg View Post
Yes there are kits out there that allow you to push start an automatic. Yes there were automatic transmissions that were once made. That allowed you to push start an automatic.

But my challenge still is open. Because unless you have that old school trans or a modified trans. Your not going to push start or pull start an automatic. Remember my challenge was for an oem trans. So a modified one would not be allowed for this challenge.
No Cunt, you need to go back and read the final posts in that thread. Pay attention to Scooter's posts, since he works at the GM Proving Grounds. It has nothing to do with old-school or modified transmissions. Get the fucking point and accept it. There is no challenge because its a known fact that it can be done.
PavementPounder is offline   Reply With Quote
Old January 5th, 2008, 07:49 PM   #31
mideerslayer
NEVER GIVE UP!
 
mideerslayer's Avatar
 
Join Date: 04-27-06
Location: Clinton Township
Posts: 3,837
iTrader: (29)
Mentioned: 0 Post(s)
Default

Good old saturday night entertainment
mideerslayer is offline   Reply With Quote
Old January 5th, 2008, 07:51 PM   #32
GreaseMonkey
Senior Member
 
GreaseMonkey's Avatar
 
Join Date: 11-04-05
Location: Madison Heights, MI
Posts: 17,985
iTrader: (22)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by bigcountrysg View Post
The man brings up the statement that I can't turn a wrench. But I never had a tire come off while driving down the road. Hmmmm who can't wrench.
So you have the invincibility from bad luck and accidents?

You're a fucking tool.

Oh, and bring the whole push starting an automatic into this thread is a real childish maneuver.
__________________
Quote:
Originally Posted by kerryann View Post
I am not a lesbian but if I was I would do her.
GreaseMonkey is offline   Reply With Quote
Old January 5th, 2008, 07:53 PM   #33
Sol Goode
Obama Nation!
 
Sol Goode's Avatar
 
Join Date: 11-05-05
Location: Curt1656 & Scooters love castle
Posts: 14,400
iTrader: (10)
Mentioned: 13 Post(s)
Default

PP = 1
Cunt Boy = 0
Sol Goode is offline   Reply With Quote
Old January 5th, 2008, 07:55 PM   #34
84Scrambler
Senior Member
 
Join Date: 11-07-05
Location: Lansing
Posts: 5,942
iTrader: (8)
Mentioned: 0 Post(s)
Send a message via AIM to 84Scrambler
Default

Do you guys have a permit and the proper license for this argument? :tonka:
84Scrambler is offline   Reply With Quote
Old January 5th, 2008, 07:58 PM   #35
unclebeaner
can you hear the banjos?
 
unclebeaner's Avatar
 
Join Date: 04-04-06
Location: Flat Rock 48134
Posts: 9,069
iTrader: (72)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by 71jeepster View Post
that would make a great youtube video!!
on pps team he has evvvvveryyythinnggggg
unclebeaner is offline   Reply With Quote
Old January 5th, 2008, 08:02 PM   #36
71jeepster
Glad I'm not Gay J. Hall!
 
71jeepster's Avatar
 
Join Date: 09-26-06
Location: Kellogg, ID
Posts: 3,091
iTrader: (12)
Mentioned: 0 Post(s)
Send a message via Yahoo to 71jeepster
Default

Quote:
Originally Posted by GreaseMonkey View Post
So you have the invincibility from bad luck and accidents?

You're a fucking tool.

Oh, and bring the whole push starting an automatic into this thread is a real childish maneuver.
Is he gonna bring that into everything PP posts on now?

Come on bigcunt give it up, you were proved wrong admit it!
71jeepster is offline   Reply With Quote
Old January 5th, 2008, 08:03 PM   #37
KartRacer
Blowd up
 
KartRacer's Avatar
 
Join Date: 11-16-05
Location: Riverside, MI 49084
Posts: 6,335
iTrader: (4)
Mentioned: 0 Post(s)
Send a message via AIM to KartRacer
Default

Quote:
Originally Posted by 84Scrambler View Post
Do you guys have a permit and the proper license for this argument? :tonka:
If I pass you on the trail stuck, I am going to drive by and laugh. :tonka:
KartRacer is offline   Reply With Quote
Old January 5th, 2008, 08:04 PM   #38
bigjay
The Man Myth And Legend
 
bigjay's Avatar
 
Join Date: 04-06-07
Location: i can piss on the allegan and barry county line at the same time.. ...
Posts: 5,121
iTrader: (1)
Mentioned: 0 Post(s)
Default

aluminum= 40 cents a lbs
bigjay is offline   Reply With Quote
Old January 5th, 2008, 08:07 PM   #39
junk90xj
ALLPRO AUTO
 
junk90xj's Avatar
 
Join Date: 11-06-05
Location: lansing
Posts: 4,550
iTrader: (47)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by 84Scrambler View Post
Do you guys have a permit and the proper license for this argument? :tonka:
yes and we didnt invite you so shhhh
__________________
http://www.apalansing.com/
junk90xj is offline   Reply With Quote
Old January 5th, 2008, 08:08 PM   #40
71jeepster
Glad I'm not Gay J. Hall!
 
71jeepster's Avatar
 
Join Date: 09-26-06
Location: Kellogg, ID
Posts: 3,091
iTrader: (12)
Mentioned: 0 Post(s)
Send a message via Yahoo to 71jeepster
Default

Quote:
Originally Posted by bigjay View Post
aluminum= 40 cents a lbs
that's more useful input then anything bigcunt has said!
71jeepster is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > General 4x4 Stuff > The Pub

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:04 PM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.29538 seconds with 80 queries