|June 21st, 2007, 08:51 AM||#1|
Long story short. I bought this truck at an auction without my wifes approval.
$2800. NEW PRICE!!! NEED THIS GONE. WORTH MORE IN PARTS!
THIS IS THE ABSOLUTE LOWEST PRICE. I WILL ADVERTISE ON HERE UNTIL JULY 24, THEN IT GOES IN THE AUTO TRADER. COME AND GET IT!!!!!
2000 K3500 crewcab short bed 4x4, 159,000miles, Vortec 454, 4L80E, ?? Tcase, 14 bolt rear, leather interior, American Eagle aluminum wheels, trailer hitch, trailer brakes, cruise, air, power, etc.... It's black with a tan interior with the wood trim kit. I ran it down the road last night up to 55 and it rides nice, brakes work good and steers tight.
Other than being rolled I know it needs mufflers, a battery, passenger rear axle seal, tires, and I smell antifreeze when the hood is open. The heater return line is leaking at the intake manifold. It needs a $15 part and a few minutes to swap. There is surface rust at the bottom of the doors. The seats are pretty worn and there are some stains in the carpeting.
I have a clean short bed with tailgate for an additional $800 I just bought to go on the truck. Bed is blue. I think both beds have plastic liners. The tailgate on this truck works and has one dent.
I have a couple pics I can email and will take more in needed.
Truck is located in Holland and has a clear title, not rebuilt, and not salvage.
Last edited by lt1yj; August 13th, 2007 at 12:46 PM. Reason: SOLD
|July 17th, 2007, 09:12 AM||#12|
Any Winchester lever action - pre '64
Winchester Model 12 or 42
Winchester Model 97
Browning BL22 rifle (little 22 really short for kids)
Winchester model 94 22 rifle (little 2 really short for kids)
9mm, 38 or 40 semi auto pistol - NOT Ruger P89....
There are quite a few tools I'd like to have.
abrasive or hydraulic tube notcher
20" Disk Sander
2 or 4 post car lift
Delta cabinet shaper
Delta or Powermatic 8" jointer
Delta or Powermatic 18"+ Planer
Sand blast cabinet - floor model
lathe tool holders and 5C collets
Roll around tool boxes, Snap on Matco Kennedy
I would also consider:
a Chevy SRW 60 front
Chevy 60 front SRW hubs
79 ford HP60 front bare housing
38 x 16.5 SX or TSL's or Irocs
427 Ford motor
427 Chevy motor 9.8 deck height
39.5 x 16.5 TSLs or Irocs
Aluminum 16, 16.5 or 17 beadlocks
fuel cell for a YJ behind the seat
Miller 251 or lincoln 255 welder
'66 impala belair or biscayne
'66 or '67 Nova
zero turn lawnmower
Clean Scrambler tub (like that actually exists)
|Thread Tools||Search this Thread|