CJ7 Juggy (Pics Added 10/16) - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
GL4x4 Live! GL4x4 Casino

greatlakes4x4.com is the premier Great Lakes 4x4 Forum on the internet. Registered Users do not see the above ads.
Search
Reply
 
Thread Tools Search this Thread
Old October 10th, 2013, 04:54 PM   #1
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default CJ7 Juggy (Pics Added 10/16)

Parting out my 1983 CJ7 Juggy. Parts for sale as follows:
-Passenger drop D60 from 1980 K30. 4.10 gears, detroit locker, hi-steer arms, king pin, GLO diff cover, new driver u-joint, new pads. Has mile marker hubs that both blew so I welded the internals together and they have worked without issue as a poor mans drive slug. Replace them if you like but they work fine as is. Comes with steering Sold
-14 bolt ff from same truck. 4-link brackets, truss, welded, disc brake conversion, new caliper (driver side), GLO diff cover, 4.10 gears, spare shafts, GLO pinion guard Sold
-SM465 trans (have 4) $125 each
-np205 t-case (have 3) $100 each
-205 JB conversion twin stick $60
-Warn HS9000i Winch is in great shape but PO hard wired remote(plug on remote has been cut). I removed remote and wired up in cab winch controls (included). I will also include remote if you want it. Sold
-3A Racing reclining bucket seats with 5-point harnesses. Seats are in decent shape with no rips but slightly faded $300 for all
-1983 CJ7 chassis. Has firewall, hood, cut fenders, grill. Back half of frame has been cut off and tubed. Full cage tied into frame and boat sides (not skinned yet). Front has beefed up leaf mounts and rear is set up for triangulated 4-link on coil springs. Front and rear winch mounts. Tubing is 1.75x.120 HREW. Has small block chevy motor mounts. Seat mounts tied into cage. Tilt steering column and clutch/brake/gas pedals Sold
-1/2 soft doors in good shape. Small rip on driver side $40
-Full hard doors in good shape $80
I will add more stuff to this list as I sort through everything. Pics to follow.

Last edited by Mr.Jefferson; November 21st, 2013 at 08:18 AM.
Mr.Jefferson is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old October 10th, 2013, 05:16 PM   #2
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 3,474
iTrader: (10)
Mentioned: 3 Post(s)
Default

Interested in seats
Waiting on pics
__________________
3rd generation jeeper

99 gmc Sierra extended cab z71 dd
87 yj Laredo 4.2/999/231 ac & cruise bone stock (for now)
90s Wrambler efi 2.5, t5, sye231 ,d44s with 4.88s and detroits
Wramblerguy is offline   Reply With Quote
Old October 10th, 2013, 06:37 PM   #3
scare-crow
the eskimo bro
 
scare-crow's Avatar
 
Join Date: 04-04-08
Location: Traverse City, MI
Posts: 2,060
iTrader: (2)
Mentioned: 2 Post(s)
Send a message via AIM to scare-crow
Default

I'd like to see pics of the chassis.
scare-crow is offline   Reply With Quote
Old October 11th, 2013, 10:12 AM   #4
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

I will get some pics up this weekend.
Mr.Jefferson is offline   Reply With Quote
Old October 11th, 2013, 10:54 AM   #5
howell_jeep
Last Free Man
 
howell_jeep's Avatar
 
Join Date: 02-09-06
Location: Howell Twp, MI 48836
Posts: 10,848
iTrader: (69)
Mentioned: 1 Post(s)
Default

Pics of seats please.

Does the winch have a synthetic rope or cable?
__________________
I SHOOT RAW!
---

Exercise your rights! Open Carry!
howell_jeep is offline   Reply With Quote
Old October 11th, 2013, 11:00 AM   #6
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

The winch has cable.

All prices are OBO.
Mr.Jefferson is offline   Reply With Quote
Old October 11th, 2013, 12:18 PM   #7
Mulely
Senior Member
 
Mulely's Avatar
 
Join Date: 11-04-06
Location: St Joseph, MI
Posts: 1,195
iTrader: (13)
Mentioned: 0 Post(s)
Send a message via AIM to Mulely
Default

Chassis pics to davemuellen@gmail.com please
Mulely is offline   Reply With Quote
Old October 11th, 2013, 01:25 PM   #8
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 3,474
iTrader: (10)
Mentioned: 3 Post(s)
Default

Click image for larger version

Name:	ImageUploadedByTapatalk1381512314.266783.jpg
Views:	653
Size:	227.4 KB
ID:	111239
I assume this is the same jeep?
__________________
3rd generation jeeper

99 gmc Sierra extended cab z71 dd
87 yj Laredo 4.2/999/231 ac & cruise bone stock (for now)
90s Wrambler efi 2.5, t5, sye231 ,d44s with 4.88s and detroits
Wramblerguy is offline   Reply With Quote
Old October 11th, 2013, 01:44 PM   #9
ckupq
Kitten I'm gonna eat you!
 
ckupq's Avatar
 
Join Date: 11-07-05
Location: Cedar Rapids, IA 52402
Posts: 3,429
iTrader: (6)
Mentioned: 0 Post(s)
Default

Awh its sad to see this parted out. Its like the pass around girl of the Vehicles for sale.
ckupq is offline   Reply With Quote
Old October 11th, 2013, 01:53 PM   #10
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

Thanks wramblerguy, thats the Jeep. That pic is a bit dated though. I have since painted it red and tubed the back half of the frame.

Haha, it has certainly been touched by many.
Mr.Jefferson is offline   Reply With Quote
Old October 11th, 2013, 01:58 PM   #11
ckupq
Kitten I'm gonna eat you!
 
ckupq's Avatar
 
Join Date: 11-07-05
Location: Cedar Rapids, IA 52402
Posts: 3,429
iTrader: (6)
Mentioned: 0 Post(s)
Default

How much for the whole thing?
ckupq is offline   Reply With Quote
Old October 11th, 2013, 03:19 PM   #12
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

Well its already pulled apart and motor has already been sold. I would sell the rest for $3k.
Mr.Jefferson is offline   Reply With Quote
Old October 14th, 2013, 04:20 PM   #13
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

Chassis does have a clear 1983 title also. All prices are OBO. Make an offer so I can clear some of this stuff out of the garage.
Mr.Jefferson is offline   Reply With Quote
Old October 14th, 2013, 05:22 PM   #14
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 3,474
iTrader: (10)
Mentioned: 3 Post(s)
Default

Would still like to see better pics of seats
__________________
3rd generation jeeper

99 gmc Sierra extended cab z71 dd
87 yj Laredo 4.2/999/231 ac & cruise bone stock (for now)
90s Wrambler efi 2.5, t5, sye231 ,d44s with 4.88s and detroits
Wramblerguy is offline   Reply With Quote
Old October 14th, 2013, 10:43 PM   #15
joe_jeep
welfare wheeler
 
joe_jeep's Avatar
 
Join Date: 03-03-06
Location: hazel park, mi
Posts: 5,856
iTrader: (37)
Mentioned: 2 Post(s)
Send a message via Yahoo to joe_jeep
Default

reminds me of my juggy.
glwts!
joe_jeep is offline   Reply With Quote
Old October 15th, 2013, 07:20 AM   #16
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

Sorry about the pics guys. The weekend got way more busy than planned and didnt have time yesterday. I will do my best to get out there and snap some pics today after work.
Mr.Jefferson is offline   Reply With Quote
Old October 16th, 2013, 09:38 AM   #17
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default





There is a recliner mechanism on each side of the seats. Both seat have one side that has had the plastic adjuster knob broken off.

Other side looks like this.

x2 5-point harness set ups like this.

Last edited by Mr.Jefferson; November 21st, 2013 at 08:25 AM.
Mr.Jefferson is offline   Reply With Quote
Old October 16th, 2013, 09:40 AM   #18
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default




Let me know if you want pics of anything else.
Sale pending on chassis.
Mr.Jefferson is offline   Reply With Quote
Old October 16th, 2013, 09:48 AM   #19
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default



Best shots I have of the axles right now.
Mr.Jefferson is offline   Reply With Quote
Old October 17th, 2013, 08:45 AM   #20
Mr.Jefferson
Rider on the storm.
 
Mr.Jefferson's Avatar
 
Join Date: 10-09-07
Location: Pinckney, Michigan
Posts: 834
iTrader: (10)
Mentioned: 0 Post(s)
Send a message via AIM to Mr.Jefferson
Default

Sale pending on winch.
Mr.Jefferson is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
Tags
meballs

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:35 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.19062 seconds with 83 queries