Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
GL4x4 Live! GL4x4 Casino







Search
Reply
 
Thread Tools
Old September 28th, 2013, 11:53 PM   #1
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
1995 Jeep Wrangler YJ Part Out

I have a 1995 YJ that I am parting out. Seats, Tub and roll bar are spoken for. Hood, fenders and grill are no good. Has a good running 2.5L motor and AX-5 transmission. T case is no good. Let me know what you need!

This is what I have to date.

-AX5 transmission with bellhousing, slave cylinder and newer clutch and pressure plate. $125 obo (SOLD)
-Starter for 2.5L engine. $25
-I have (2) stock rear drive shafts $25 each
-Rear Tail lights $10 a set (Have 2 sets)
-Dana 30 and Dana 35 axles with 4.10 gears $150 obo
-Newer radiator for 2.5L $50 (SOLD)
-Set of factory steel half doors (Red) excellent condition. NO RUST $350 obo (SOLD)

I also have numersous small parts and full door parts inclusing good glass if anyone is interested. I am sure that I have missed some parts, no be afraid to ask what I have.

Last edited by celrod77; October 13th, 2013 at 07:52 PM.
celrod77 is offline   Reply With Quote
Old September 29th, 2013, 08:20 AM   #2
Super
Newbie
 
Super's Avatar
 
Join Date: 06-02-13
Location: Up North
Posts: 6
iTrader: (0)
Looking for front driver and passenger seatbelts. Also interested in the tailgate assembly, hard or soft top and doors. Thanks so much.
Super is offline   Reply With Quote
Old October 2nd, 2013, 10:47 PM   #3
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
TTT, Let me know what you need!!!!
celrod77 is offline   Reply With Quote
Old October 4th, 2013, 08:11 PM   #4
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Tailgate, 2.5L motor and ECU SOLD
celrod77 is offline   Reply With Quote
Old October 6th, 2013, 08:18 PM   #5
fordbronco
Look at that flex!
 
fordbronco's Avatar
 
Join Date: 02-22-11
Location: Marlette, Michigan
Posts: 3,397
iTrader: (2)
Rims?
fordbronco is offline   Reply With Quote
Old October 6th, 2013, 09:10 PM   #6
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Sorry, had aftermarket wheel that have sold.
celrod77 is offline   Reply With Quote
Old October 11th, 2013, 08:40 PM   #7
Kilrothi
Newbie
 
Join Date: 06-12-13
Location: Lancaster
Posts: 11
iTrader: (0)
How about the dash? Also, did it have a lift on it? If not, how about the stock rear springs, still have them?
Kilrothi is offline   Reply With Quote
Old October 11th, 2013, 09:40 PM   #8
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Quote:
Originally Posted by Kilrothi View Post
How about the dash? Also, did it have a lift on it? If not, how about the stock rear springs, still have them?
Sent you a PM
celrod77 is offline   Reply With Quote
Old October 13th, 2013, 07:53 PM   #9
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Let me know what you need.
celrod77 is offline   Reply With Quote
Old October 20th, 2013, 09:07 PM   #10
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Ttt
celrod77 is offline   Reply With Quote
Old October 21st, 2013, 10:28 PM   #11
Jeepguy3
Newbie
 
Jeepguy3's Avatar
 
Join Date: 12-17-11
Location: Saginaw.MI
Posts: 22
iTrader: (1)
Do you still have the soft top, roll bar, and transmission crossmember?
Jeepguy3 is offline   Reply With Quote
Old October 21st, 2013, 11:07 PM   #12
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Quote:
Originally Posted by Jeepguy3 View Post
Do you still have the soft top, roll bar, and transmission crossmember?
Sent PM
celrod77 is offline   Reply With Quote
Old November 14th, 2013, 12:55 PM   #13
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 2,473
iTrader: (8)
i need the exhaust hanger that goes under the tranny mount, both pieces
__________________
3rd generation jeeper

98 grand cherokee dd
90s wrambler efi 2.5, t5, sye231 ,d44s locked with 4.88s
http://www.greatlakes4x4.com/showthread.php?t=236415
Wramblerguy is offline   Reply With Quote
Old November 14th, 2013, 11:34 PM   #14
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Quote:
Originally Posted by Wramblerguy View Post
i need the exhaust hanger that goes under the tranny mount, both pieces
Let me see if any of the ones I have are usable. One of them I know was welded to the skidplate and I had to cut it off. I will let you know.
celrod77 is offline   Reply With Quote
Old November 15th, 2013, 05:40 AM   #15
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 2,473
iTrader: (8)
Quote:
Originally Posted by celrod77 View Post
Let me see if any of the ones I have are usable. One of them I know was welded to the skidplate and I had to cut it off. I will let you know.
Sweet, thanks
__________________
3rd generation jeeper

98 grand cherokee dd
90s wrambler efi 2.5, t5, sye231 ,d44s locked with 4.88s
http://www.greatlakes4x4.com/showthread.php?t=236415
Wramblerguy is offline   Reply With Quote
Old November 19th, 2013, 11:44 AM   #16
4x4klein
Weapon K
 
4x4klein's Avatar
 
Join Date: 02-14-07
Location: Holly
Posts: 1,404
iTrader: (52)
Quote:
Originally Posted by celrod77 View Post
-Dana 30 and Dana 35 axles with 4.10 gears $150 obo
Wheel bearings, seals, and brakes in good shape?
__________________
4x4klein is online now   Reply With Quote
Old November 19th, 2013, 11:12 PM   #17
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Quote:
Originally Posted by 4x4klein View Post
Wheel bearings, seals, and brakes in good shape?
Axles sold.
celrod77 is offline   Reply With Quote
Old November 25th, 2013, 05:54 PM   #18
Buggy_Tim
(513) 891-8372
 
Buggy_Tim's Avatar
 
Join Date: 11-05-05
Location: Sault Sainte Marie
Posts: 11,605
iTrader: (12)
I need a air box and tube
Buggy_Tim is offline   Reply With Quote
Old November 26th, 2013, 12:05 AM   #19
celrod77
Senior Member
 
Join Date: 01-15-13
Location: Chesaning, Michigan
Posts: 119
iTrader: (4)
Quote:
Originally Posted by Buggy_Tim View Post
I need a air box and tube
Sorry that sold with the motor
celrod77 is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -5. The time now is 11:55 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
Copyright 2005 - 2012 Cracker Enterprises - Powered by Linux
vB Ad Management by =RedTyger=
Page generated in 0.18341 seconds with 48 queries