220 Volt Mig Welder $300 - Sold
I bought this welder for a jeep project but now I am moving and would like not to have to drag it along with me. It is a Solar Brand Wire Feed Mig Welder - Model 2175 on a rolling cart. Was used at a local body shop that closed before my friends dad bought it. than I bought it off him. 180 amp 220 volt single phase infinite heat and wire speed controls - 160 peak amps Welds from thick, 5/16- inch steel to thin, 26-gauge sheet metal. Electronic wire speed control (0 to 700 inches per minute) and infinite heat control easily tune the precise speed and heat needed for the job. Wire feed meter monitors wire speed for accuracy and easy reset. Quick-release drive system allows easy wire change without additional tension adjustment. Fan Cooled. Built-in spot/stitch timer lets you repeat spot (plug) and stitch welds. Convenient purge/advance switches allow separate gas purge or wire advance for efficient use. Small to large spool capacity. Complete with regulator, added on large mig gun, ground clamp, rolling cart, original instructions and I will throw in what's left of a 10 lb. roll of wire.(no tank included, it was leased). You are more than welcome to try it out. I only have a little time on it but it seems to weld good and the price is almost half of what I paid. 906 370 759Zero. Located in Gaylord, MI.
Last edited by mudslinger101; August 14th, 2013 at 10:10 PM.