89 YJ part out - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
GL4x4 Live! GL4x4 Casino

greatlakes4x4.com is the premier All Forum on the internet. Registered Users do not see the above ads.
Search
Reply
 
Thread Tools Search this Thread
Old June 10th, 2013, 03:47 PM   #1
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default 89 YJ part out

This was an 88 YJ, automatic, I6, hard top.

Frame isn't rusted through anywhere, but it's pretty bad.
floorboards are rusted through, front fenders are shot, rear fenders have lots of bondo. Tailgate is bent in a little from some idiot pushing the jeep with a truck (me)

Complete drivetrain is available. Engine block is cracked, but I have another I6 that runs. Interior is complete and in good shape, carpet looks good, rear seat looks good, driver seat is ripped. Roll bar is complete with covers. Hood is solid, windshield frame is a little rusty, but doesn't look bad. Glass is good. Brand new front calipers, master cylinder, and transmission mount, 0 miles. Good radiator.

running 4.2 I6 - $150
TF999 - $100
NP231 - $100
complete axles $100/each

PM me with offers or questions about parts. A lot of it I'll probably have to check condition on when there's interest. I'm really not looking to get rich, just make back some of my money.

I do have the title.



Last edited by Memphis1967; June 20th, 2013 at 08:02 AM.
Memphis1967 is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old June 10th, 2013, 08:55 PM   #2
big86inthestixx
Senior Member
 
big86inthestixx's Avatar
 
Join Date: 04-30-11
Location: howard city Mi
Posts: 2,079
iTrader: (9)
Mentioned: 2 Post(s)
Default

Does it have the pcm yet?
Where r u located?
Can i get a picture of the pcm?
How much?

Thanks. .

sended frum dis stoopid fone.
big86inthestixx is offline   Reply With Quote
Old June 11th, 2013, 07:21 AM   #3
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default

PCM is there.
I'm in the Soo, north eastern end of the UP.
I can get a picture after I get off work at 5pm.
$55 shipped
Memphis1967 is offline   Reply With Quote
Old June 11th, 2013, 07:25 AM   #4
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default

gauges are also spoken for
Memphis1967 is offline   Reply With Quote
Old June 11th, 2013, 08:50 PM   #5
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default


PCM, still shiny

Sent from my SCH-I535 using Tapatalk 2
Memphis1967 is offline   Reply With Quote
Old June 11th, 2013, 09:32 PM   #6
big86inthestixx
Senior Member
 
big86inthestixx's Avatar
 
Join Date: 04-30-11
Location: howard city Mi
Posts: 2,079
iTrader: (9)
Mentioned: 2 Post(s)
Default

Bummer. ..its not the one I need, need the plastic one that goes in the engine compartment. ..rock took my buddies out. .lol

sended frum dis stoopid fone.
big86inthestixx is offline   Reply With Quote
Old June 18th, 2013, 08:22 AM   #7
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default

Top and doors now available. Both are in great shape. The hatch handle on the top doesn't work, I haven't looked at it close. $200 for both doors, $200 for the top, or make me an offer
Memphis1967 is offline   Reply With Quote
Old June 20th, 2013, 06:06 AM   #8
larryl
just a jeep
 
larryl's Avatar
 
Join Date: 02-14-11
Location: howard city
Posts: 160
iTrader: (2)
Mentioned: 0 Post(s)
Default

windshield frame Complete $
larryl is offline   Reply With Quote
Old June 20th, 2013, 07:35 AM   #9
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default

$150 obo for the windshield frame. Very little rust on the outside, I saw some on the inside lower edge, but I couldn't get a real good look behind the dash. What I saw didn't look too bad.
Memphis1967 is offline   Reply With Quote
Old June 20th, 2013, 07:42 AM   #10
cdw32
Senior Member
 
cdw32's Avatar
 
Join Date: 10-08-10
Location: Commerce MI
Posts: 474
iTrader: (8)
Mentioned: 0 Post(s)
Default

How many miles on the trans? Did it work a it should? Very interested in it.
cdw32 is offline   Reply With Quote
Old July 2nd, 2013, 10:14 AM   #11
Memphis1967
Member
 
Join Date: 11-21-07
Location: MI
Posts: 59
iTrader: (1)
Mentioned: 0 Post(s)
Default

sale on complete Jeep pending. running 4.2 still available
Memphis1967 is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:43 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.14991 seconds with 55 queries