|January 13th, 2013, 06:08 PM||#1|
Old School Jeep Fan
79 J20 Lots of extra parts Lima,OH
Well I have come on to some hard financial times and I need cash more then i need my Jeep right now. I really really don't want to sell this truck but I must do what is right for my family. I know its the holidays but thats normally when tough times present themselves.
The truck runs good and has a lot of power and drives pretty well down the road. I have bought almost all the parts needed to restore this truck(bed, doors,fenders, front valance and core support)
79 J20 8600lb
360 w/RV cam,Mallory uni light dizzy, Edelbrock Shorty headers,
T-18/Dana 20 combo(twin sticked)
HD44 Front 3.73 gears
Dana 60 rear with disk brake conversion 3.73 gears
Side Pipe exhaust
4in Lift with Procomp shocks
-Disk brakes in the rear
-BJ's rear bumper
-Trailer light wiring(7pin and 4pin)
-Newer rims and tires(7k or so on them)
-Newer bench seat from 86 J truck(not installed)
-New power steering box
-Power steering pump prolly needs replaced its the org. one (I have a new one)
-Windshield is cracked
-Cab is rusted out above the windshield(can be fixed)
-New floors pans were put in but i never got around to finishing them around the driver side seat belt
-Front valance is rusted(have a rust free one to go with the truck)
-Pass side fender is rusty(have rust free one to go with)
-Bed is in rough shape(have a rust free one to go with the truck and a tailgate)
-Doors are in good shape but the inside lip is a little soft(again i have a rust free set with good glass to go with the truck)
-Clutch slips only in 4th when you floor it( have a new one in the box)
-Rust free bed,doors,fenders,front valance
-Spare sliding rear window
-Extra T-18/Dana 20 combo
-fully machined block and heads and crank(have pistons and rods as well)
-Spare parts motor good for a re-builder
-2 full gasket sets(all FelPro)
-Brand new clutch
-truck topper for the bed(meant for a Jtruck)
I'm sure i'm missing stuff ill post if i find more.
I'm asking $3900 for EVERYTHING! I will not part out body panels. I will let go of the motors and engine parts(minus one gasket set).
I will look at offers but do not low ball me. I have a lot more in all of the parts then what i'm asking for them and the truck. I think this would be a great resto project for someone. I have all the major components to complete the truck.
I will take a partial trade on a 4cly car ie: Honda civic, a TDI of sorts prefer a manual trans.
Feel free to message me or email me at firstname.lastname@example.org i will be more then happy to send pics and answer any questions
|Thread Tools||Search this Thread|