|May 8th, 2012, 02:18 PM||#1|
Join Date: 03-16-08
Shop in SE MI to check D-shaft balance??
I just finished a build and have what feels like a driveline vibration.
Jeep has new shafts that were built by Tatton in UT.
I have gone through the process to confirm angles, etc....
Looking for someone local who can spin the front shaft and determine if it is out.
Spoke to B&L today and they want $65 to look at it.......seems really steep.
Anyone have a local contact that could check it out.
All I am looking for is someone to confirm if it is a balance issue vs. something structural...............I'll be taking it up with Tatton from there regarding next steps.
Thanks for your help.
|May 9th, 2012, 04:07 AM||#2|
Join Date: 01-28-08
I had mine done at Shaftmaster in Lincoln Park.
I'm sure others on here will agree that they do awesome work.
1668 John A. Papalas Dr.
Lincoln Park, MI 48146
|June 13th, 2012, 04:26 PM||#6|
Join Date: 11-06-05
Location: Dearborn Heights, MI
it's a bit far from Oxford, but Joint Clutch in Romulus has done all the shafts for the race buggy without a single issue.
They are also a sponsor for our team. Support companies that support local racers and our sport.
Special Thanks and Recommendations to;
PAC Racing Springs
Joint Clutch and Gear
|June 13th, 2012, 09:55 PM||#7|
In Da Faaaaaace!!!
Join Date: 12-25-05
Location: WMU Kzoo Mi / Livonia, MI
drill hole, add trans fluid, weld hole shut, grind smooth. Seriously, this is what I did with mine. You can watch it spin all wobbley like, but going down the road no vibes.