2000 GMC Sierra 3500 Reg Cab 8' Box - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicles for sale
GL4x4 Live! GL4x4 Casino

greatlakes4x4.com is the premier Great Lakes 4x4 Forum on the internet. Registered Users do not see the above ads.
Thread Tools Search this Thread
Old November 30th, 2011, 02:08 PM   #1
Join Date: 01-09-10
Location: MI
Posts: 5
iTrader: (0)
Mentioned: 0 Post(s)
Default 2000 GMC Sierra 3500 Reg Cab 8' Box

Asking $6750

-Regular cab-
-Long box-
-Classic body style tan-ish in color-
-Auto trans-
-350 V8-
-Manual windows and locks-
-Cruise control-
-Tilt wheel-
-Sliding rear window-
-Bed liner-
-Tow package-
-About 89k on the truck-

The body has some dents and surface rust (rust along the bottom typical of most Chevy's of these years, but there's no big rust holes, I replaced the cab corners but haven't quite "finished" them yet.) The driver's door has a crease at the bottom, it appears a previous owner swiped a post or something similar, but still opens and closes fine. Tires are about 50% with a little weatherchecking. Windshield has no cracks but it does have scratches like someone ran worn out wipers or they were dirty for a while.

As of 3/2010:

New front hub assemblies..
New pitman arm and alignment..
New coolant temp sender..
Exhaust donuts replaced..
Hose and fitting from heater core to intake replaced..
Rear axle fluid changed at about 74k..
Replaced mass air flow unit with a used one that works..
Fuel pressure was tested and read 50+psi..

4/18/2011 - New Bosch Platinum+2 plugs
6/11/2011 - New front rotors and pads at 86k, new one-person bleeders installed in front. New shoes installed in rear as well. Replaced both rear wheel cylinders and brake lines from splitter. Have old shoes still in good shape, could clean up and use again but I changed them due to the wheel cylinder leaking.

Contact 906-370-FOUR ONE TWO FIVE
Truck is located in HOUGHTON, MI

TOOL BOX NOT INCLUDED -------- Currently has everything needed to put on a Western Ultramount plow (not including a blade with this truck) which I will remove, or include with the truck for $7000 total. Which to buy all the wiring, mounts, and plow pockets you're looking at $1000+!!

The tires in the pictures aren't the same ones that are in the descricption.

KBB Values:


Very Good



Last edited by kmollanketo; November 30th, 2011 at 03:18 PM.
kmollanketo is offline   Reply With Quote
Sponsored Links
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicles for sale
chevy 4x4 gmc one ton

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:00 AM.

Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.10214 seconds with 28 queries