|October 1st, 2011, 05:57 AM||#1|
SOLD 73 Bronco Mud Truck Project SOLD
Rebuilt 460 (1969) with high compression heads, 4x4 cam,
Valve job, aftermarket roller rockers, MSD ignition
Professionally rebuilt C-6, B&M shifter, NP205 transfer case
Axles are HP Dana 44 and Ford 9 inch from 77 F-150 (full width)
Yukon 4.56 gears (professionally installed) all new bearing/ seals
Detroit trutrac in front, full spool in rear. Front has new ball joints
U-joints, wheel bearings, rotors and pads, warn prem lockouts.
Rear axle converted to disk brakes, new pads and rotors
Frame and axles were sandblasted and painted with POR15
5.5 in CAGE offroad lift kit. (Leaf pack not add a leaf)
Radius arm extensions
3 in body lift
Fiberglass front clip and door inserts
New striker posts, rocker panels, and rear fenders
Set up for power steering, have parts for hydroboost brakes
Extra C-6/ NP 205
It is set up as a half cab, with the body cut off at the back of the bulkhead.
I planned to put the radiator and battery in back and hang the fenders
from the rollcage.
It needs finishing. -bodywork, wiring, rollcage, etc. I have two kids now and I
don't have the time or money to finish it. Was $3000 NOW $2500
Last edited by mudford; October 25th, 2011 at 06:42 PM. Reason: Lower price