40 foot Raptor 5th wheel Toyhauler Sold! - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > 4x4 Talk > Tow rigs and trailers
GL4x4 Live! GL4x4 Casino

greatlakes4x4.com is the premier Great Lakes 4x4 Forum on the internet. Registered Users do not see the above ads.
Search
Reply
 
Thread Tools Search this Thread
Old June 25th, 2014, 12:31 PM   #1
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default 40 foot Raptor 5th wheel Toyhauler Sold!

5th wheel toy hauler Raptor toyhauler 14' garage lots of upgrades and very clean.

2006/2007 Raptor 3814ss in great condition. I towed it mostly with a 2500 dodge cummins single rear wheel and it hauled great, even in strong cross winds......best tank >12 mpg...worst ever was in the 9's

Garage is over 14 foot long and will fit four full sized quads, sand rail or even a jeep. It has a great open floor plan that is completely usable with the super slide in as well, so you don't have to put out the slides to use it while traveling. It has a ton of options and upgrades some of which are listed below.

Onan 5500 generator runs great, new carb and plugs last year.
Hydraulic high speed supplemental landing jack (awesome upgrade!)
Full length E track in garage
Rubber diamond plate floor in garage
Gladiator track on walls in garage
10,000 lb. D rings bolted through frame for UTV or Jeep
50 amp setup wired for up to 3 ac units
New style LED tail lights
New 16" wheels with matching spare wheel
245 E rated LT truck tires
Screen room rolls up over rear door,
Can use rear door horizontally as a deck
Dedicated battery for generator and hydraulic landing jack
15 w Solar panel on roof
Fantastic fan in garage area and two smaller exhaust vent fans
30 gal fuel station
Huge awning in good shape
Updated rear work lights on back of trailer
High pressure black tank washout
Exterior fiberglass and graphics in great shape!
Outside entertainment center
Extra plugs in basement and generator compartment for air compressor and power tools
Huge unobstructed pass through basement area
Rubber diamond plate step pads front and rear

Cons

Automatic generator transfer switch does not work, I have been using it as a manual switch, the nice thing is that it does not hum when using it now. I may have this repaired soon.

Several Small "door dings" in the aluminum lower skirt near the back where the kids parked their bikes, and paint is slightly faded under gas tank filler, that may wax out but have not tried yet.

I also have a 5th airborne sidewinder suspension pin box available separately that that allows for use with shortbed trucks without a slider. Not only does it ride way better, and keep you from hitting the cab, it also allows the trailer to follow the truck tracks when cornering more than a standard pin box. Price for the pin box separately is $750

This trailer has been taken care of very well, and looks fantastic. We just used it two weeks ago, so throw your stuff in, and it is ready to go. I would consider local delivery if needed. Title is clean and clear.SOLD!
Attached Thumbnails
Click image for larger version

Name:	image.jpg
Views:	347
Size:	51.0 KB
ID:	117166  

Last edited by cruiserdar; July 17th, 2014 at 11:05 PM.
cruiserdar is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old June 26th, 2014, 08:24 PM   #2
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default

Another angle
Attached Thumbnails
Click image for larger version

Name:	image.jpg
Views:	311
Size:	94.4 KB
ID:	117190  
cruiserdar is offline   Reply With Quote
Old June 26th, 2014, 09:26 PM   #3
jhnyquest
goof ball
 
jhnyquest's Avatar
 
Join Date: 05-26-08
Location: West Olive
Posts: 26,421
iTrader: (18)
Mentioned: 9 Post(s)
Default

Pics of inside, and garage area. What are overall dimensions of ramp opening?
__________________
...
jhnyquest is offline   Reply With Quote
Old June 26th, 2014, 10:18 PM   #4
chevotass
Senior Member
 
chevotass's Avatar
 
Join Date: 11-02-06
Location: goodrich
Posts: 6,769
iTrader: (22)
Mentioned: 24 Post(s)
Send a message via AIM to chevotass
Default

Quote:
Originally Posted by jhnyquest View Post
Pics of inside, and garage area. What are overall dimensions of ramp opening?
41 ft Raptor Toyhauler buildup. Making a Jeep or Land Cruiser fit a RV Toy hauler - Great Lakes 4x4. The largest offroad forum in the Midwest
chevotass is offline   Reply With Quote
Old June 26th, 2014, 10:49 PM   #5
mudrunner456
Senior Member
 
mudrunner456's Avatar
 
Join Date: 10-29-06
Location: north muskegon, MI
Posts: 747
iTrader: (7)
Mentioned: 0 Post(s)
Default

Any idea what it weighs?
mudrunner456 is offline   Reply With Quote
Old June 27th, 2014, 05:32 PM   #6
cyrus
grow old, not up.
 
cyrus's Avatar
 
Join Date: 11-10-05
Location: east of the tulips.....
Posts: 1,045
iTrader: (6)
Mentioned: 2 Post(s)
Default

Dars rig is vary nice, clean, and well maintained. He is a bit OCD when it comes to maintenance....

wish I had an extra 26k lying around. id pick it up.

he wedges a land cruiser on 40's on there....your 151 buggy will fit I'm sure jhnyquest.
__________________
R/T
'99xj
01 PSD
'97tj
Southern Michigan Rockcrawlers
"I spent most of my money on alcohol, women and jeeps . . . the rest I just wasted. . ."
cyrus is offline   Reply With Quote
Old June 28th, 2014, 05:44 PM   #7
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default

I'll get some pics up when I get home in a few days. The door is 7 foot tall and plenty wide for a rig with full size axles. You actually gain more than 7 feet ht. As your rear tires are on the lower beaver as your cage gets under the door...my old cage made my ht. 7'2" and it drove right in....lots of room to move around the rig and tie it down.

It weighed about 18,000 completely loaded with water fuel tools parts and my land cruiser. I think it was 11,500 lbs empty
cruiserdar is offline   Reply With Quote
Old June 29th, 2014, 09:11 PM   #8
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default

Rear door opening is 7'10" wide and 7' 4" tall...I double checked the length it is just a hair over 14' total length in the garage.

After spending a week in our new cyclone, I realized how much better the build quality is on the Raptor....the newer one has a few more do dads, and matches my tow rig, but the Raptor is a better built trailer.
cruiserdar is offline   Reply With Quote
Old July 11th, 2014, 08:46 AM   #9
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default

I just lowered the price on here and eBay.
cruiserdar is offline   Reply With Quote
Old July 17th, 2014, 11:06 PM   #10
cruiserdar
Senior Member
 
cruiserdar's Avatar
 
Join Date: 07-21-08
Location: Howell
Posts: 395
iTrader: (7)
Mentioned: 0 Post(s)
Default

Sold
cruiserdar is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > 4x4 Talk > Tow rigs and trailers

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:13 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.16307 seconds with 54 queries