|May 30th, 2015, 04:48 PM||#49|
Kickin' Up MUD
Join Date: 11-04-09
Mentioned: 26 Post(s)
Hey man I have a 07 Polaris ranger crew. The front seat has a about a 5-6 inch straight cut in it. Theres no missing material. Just a clean cut. Do you think you would be able to fix that? It's right between the two silver sections on this seat right where the drivers ass would sit. Its only in the black section! This is the exact seat! Thanks!
If you dont like it, get out.
|August 17th, 2015, 12:57 PM||#50|
Join Date: 11-06-05
Location: Dearborn Heights, MI
Mentioned: 15 Post(s)
FYI- I had Jesse refinish the foam on my F150 (with 200K miles on it) and the foam feels like new again. Before, the drivers side bolster was pretty well non-existent and the left side of the bottom pad was so worn I was pretty much sitting on an angle in the drivers seat. I have no idea what he did, other than now its flat, level and the bolster is back so I don't fall to the left just sitting in the seat! And it was cheaper than other shops quoted me by a fair amount...
Special Thanks and Recommendations to;
PAC Racing Springs
Joint Clutch and Gear
|Thread Tools||Search this Thread|