|May 1st, 2010, 08:38 PM||#1|
1985 CJ7 Wheeling Rig 8.1L,TH400 Stak 3 speed 42 IROKS
Selling my Rig.
It's titled as a 1985 Cj7
Dana 60's front and rear axles
ARB's in both
35 Spine Chrome Moly Shafts Front and Rear
Rear Cutting Brakes
3 link with track bar in fronk
2"- 1/4"wall Link Arms
Joint Joint Link Ends
14" Travel 2.5" Body 3" Coil Spring KING Coilovers
Rear is Spring over with Traction bar
3/8" Flat bottom Skid Plate
High Angle Drive Shafts
2003 Chevy 8.1L 496 BBC Motor 10,000 miles
Wiring is stand alone factory harness (DONE right no cut wires)
Reprogramed Computer tuned 50-75 extra horse.
Check Engine light wired in (Swap done right throws no codes)
TH400 $1300 rebuild last July.
Stak 3 Speed Monster Box 5.44:1, 3.05:1, and 1:1
42" IRoks on 17" Bead locked Rims
PSC Full Hydraulic Steering
5 point Hardness Driver and Pass
This is a wheeling rig Body is solid Tub is 90-95% 3/16 Steel Plate
Custom Fenders and Flares
No Rust. Lots of Scratches and a few Dents
Looking for $16,000 open to trades
Last edited by cjd-cj7; May 1st, 2010 at 08:41 PM.
|August 24th, 2010, 05:59 PM||#13|
Same info as above just a couple new dents and scatches from a couple wheeling trips.
Also front AXLE has been 100% rebuilt. Drive line and steering angles corrected new inner axle seals. New seals on the hubs New axle Tube seals from MAD4x4. Drives down the road allot better. New King Pin kit.
Still looking for $16,000 OBO.
|August 24th, 2010, 05:59 PM||#14|
If she doesn't sell, as much AS I would hate to do it. I will start to part her out.
Here is a list of what I would be looking to get. Open to reasonable offers.
Once I most of the stuff spoken for I will start to take her apart.
Jeep Part out
Front axle:w/steeering $3,500
Rear axle $1,500
Front drive shaft $400
Rear Drive shaft $250
Oil Coolers $35
Trans 2 $35
Power Steering $35
Hrydro Boost w/ Master $250
Stak Box $2,000
Body w/cage $1,500
Control Arms w/ Joints $200
Tires w/ Rims $1,750
Fuel Cell $250
|Thread Tools||Search this Thread|