1992 straight axle ranger sold!!!! - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Completed Sales
GL4x4 Live! GL4x4 Casino

Completed Sales A place to find the market value on parts/vehicles

greatlakes4x4.com is the premier All Forum on the internet. Registered Users do not see the above ads.
Search
 
 
Thread Tools Search this Thread
Old September 30th, 2009, 02:34 PM   #1
muddywater
Stacks bring the awesome
 
muddywater's Avatar
 
Join Date: 01-14-07
Location: muskegon,mi
Posts: 5,385
iTrader: (15)
Mentioned: 1 Post(s)
Send a message via AIM to muddywater Send a message via Yahoo to muddywater
Default 1992 straight axle ranger sold!!!!

parting out becuase i want something smaller. i just changed teh oil today to make sure nothing was messed up from sitting 3 months. started it up and its missing on one cylinder. clears out with a steady foot so its pry gonna need some tlc on the motor aspect. transmission shifts through all gears fine and reverse. t case is a 1354 manual. works great. front axle is a 79 dana44 4.56 gears. high steer, on has the pass side high steer arm on it. knuckles themselves are reamed out for 3/4 hiem joints. knuckles are chevy dana 44 flat top knuckles. has brand new ball joints and brakes on the front. does not have a tie rod that comes with it. one in picture is borrowed will have to go back to owner. rear axle is a 31 spline 9inch 4.56 gears and detroit tru trac. wheel seals are shot they are leaking bad. wheel bearings are good still. tires on truck are 35x15.5x15 tsl sx's on 15x10 wagon wheels. i have a matching set of black d window wheels that are the same size. bolt pattern is 5x5.5. body panels on truck are smashed up from trails. cab has a 12 point nhra/ihra approved cage. prebent kit from jegs. needs some touch up work on welds. driveshafts are homemade. i will separate gears from axles. i will not separate tires and wheels. truck is located in muskegon. i can deliver most of the parts if you pay for fuel.

4.0 motor and mazda trans-250.00
1354 manual t case-200.00
4.56 gears front and rear-250.00
9inch tru trac-250.00
d44 complete housing with shafts-250.00
9inch housing and bare third-100.00/9inch complete with gears and carrier-350.00
chassis-200.00 with title.
35x15.5x15 with rims-350.00










Last edited by muddywater; October 8th, 2009 at 05:36 PM.
muddywater is offline  
Sponsored Links
Advertisement
 
Old September 30th, 2009, 03:18 PM   #2
CheapThrillB2
FAWK YEAH!!
 
CheapThrillB2's Avatar
 
Join Date: 09-06-06
Location: Middleville, MI
Posts: 30,959
iTrader: (61)
Mentioned: 3 Post(s)
Default

FYI the pas knuckle is Chevy flat top from a D44.
CheapThrillB2 is offline  
Old October 1st, 2009, 09:25 AM   #3
two_much_talk
sit down shut up and ...
 
two_much_talk's Avatar
 
Join Date: 06-13-06
Location: MI
Posts: 5,654
iTrader: (32)
Mentioned: 0 Post(s)
Default

what's the D44 out of ?
two_much_talk is offline  
Old October 1st, 2009, 10:41 AM   #4
CheapThrillB2
FAWK YEAH!!
 
CheapThrillB2's Avatar
 
Join Date: 09-06-06
Location: Middleville, MI
Posts: 30,959
iTrader: (61)
Mentioned: 3 Post(s)
Default

77 f150...it has the wedges cut off and leaf pads welded on.
CheapThrillB2 is offline  
Old October 2nd, 2009, 12:01 PM   #5
two_much_talk
sit down shut up and ...
 
two_much_talk's Avatar
 
Join Date: 06-13-06
Location: MI
Posts: 5,654
iTrader: (32)
Mentioned: 0 Post(s)
Default

thanks
two_much_talk is offline  
Old October 8th, 2009, 08:05 PM   #6
MJ_Silver_1988
Senior Member
 
MJ_Silver_1988's Avatar
 
Join Date: 04-06-08
Location: Gillette, WY
Posts: 877
iTrader: (8)
Mentioned: 0 Post(s)
Send a message via AIM to MJ_Silver_1988
Default

SOLD thanks lookin forward to gettin it home
MJ_Silver_1988 is offline  
 
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Completed Sales

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:29 PM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.12127 seconds with 40 queries