Great Lakes 4x4. The largest offroad forum in the Midwest banner

Mr. Beefy's "not quite yet U4 buggy" build

358K views 3K replies 117 participants last post by  Mr. Beefy 
#1 · (Edited)
Alright fine, I'll make a new build thread :finger: :sonicjay:

Bought a MandM offroad chassis from PJ, super good dude to deal with and super nice. HIGHLY recommend. http://mandmfab.com/id68.html
This is chassis #20

Order placed on Monday 11-5 at about noon..

Got this on 11-6.




11-9






11-12


11-13

 
See less See more
10
#1,654 ·
So went to turtle ridge....did some crazy shit. Shouldn't of been able to drive it onto the trailer, but could :woot:.

Front driveshaft bearing is whooped out again. Have 3 more new ones still on the shelf lol. Other then some dents in some lower tubes, haven't noticed any other issues.

And I am now able to get buggy in/out of my trailer with big tires on. Made my front winch a suck down, and if I make one fender able to drive on I can clear in/out just barely. This is a huge deal!
 
#1,666 ·
http://youtu.be/X6kbohURLTQ

Went competed at rock solids event in sand lake last night. Tried to put on a show. Pretty sure I broke my front ring and pinion in the process and smashed another oil filter. Need to fix that oil filter issue. On violent compression of front suspension my upper link bar hit my filter just enough to bend it and cause a leak at the block.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top