Great Lakes 4x4. The largest offroad forum in the Midwest banner
281K views 3K replies 91 participants last post by  jbsjunk 
#1 · (Edited)
This will finally get put together ! I'm looking at running a lot of the parts off my jeep plus some new cool stuff lolso as of now it will be on a 14 bolt rear four link a 60 front four linked full hydro . 16 inch rear 2,5 air shocks and 14 fronts. 2.5 four inch travel air bumps all four corners. aluminum lower links with 1.25 joints.44 cut boggers on 16.5 h1s.
built 92 fuel injected 302 running on e-85 with a c-6 and 205 combo. im ether going to run 1350 or 14xx drive shaft joints just not sure yet.it will have an artcar shifter and a jb fab twin stick kit. all the seats will be corbea with five point harnesses. im sure im missing something so I will update as parts come in !
 
See less See more
2
#668 ·
Going to try to get a nite or two in on it this week


Sent from my iPhone using Tapatalk
 
#678 ·
I'm doing all aluminum on the body it will be individual panels for each triangle on the sides
 
#683 ·
I was thinking I might try to make something out of aluminum


Sent from my iPhone using Tapatalk
 
#692 ·
I have one 4x8 sheet. I need a big sheet 5x8 probably to do the roof because its over 48" wide and misc. stuff for interior, I will have a lot of interior panels because im boxing in the whole rear section too. do you have big pieces or is it all small scrap stuff? what thickness?

good progress by the way...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top